We have designed, constructed and tested an eight-pole superconducting rotating machine, based on an unconventional topology that could potentially lead to a significant increase in power density. Calculations have been carried out in two steps: estimation of the magnetic scalar potential from a Coulomb formulation using the Markov chain Monte Carlo (MCMC) method, and the calculation of the flux density by derivation of the potential using a regularization method. The use of the MCMC method enables the calculation of the magnetic scalar potential in selected regions of the discrete geometry, which is an important factor to minimize the computation time. The principle of the operation has been validated by a successful testing of the motor showing this novel configuration of an electrical motor as very promising
High-Temperature Superconductors (HTS) considerably accelerate the development of superconducting machines for electrical engineering applications such as fully electrical aircraft. This present contribution is an overview of different superconducting materials that can be used as magnetic screens for the inductor of high specific power electrical machines. The impact of the material properties, such as the critical temperature () and the critical current density (), on the machine performances is evaluated. In addition, the relevance to flux modulation machines of different HTS bulk synthesis methods are addressed.
30 October 2009 in IEEE Transactions on Industrial Electronics
An original superconducting synchronous motor topology is presented. The inductor combines both bulk materials and wires to create an alternating magnetic field in the air gap of the motor. A prototype that uses NbTi superconducting wires and YBCO bulks has successfully been designed and constructed. Test results are presented. In the second part of this paper, the possibility of higher power motor is discussed. To do so, the active length needs to be increased. In this paper, a multistack structure is proposed, and computation results show the effectiveness of the suggested approach.
2 March 2016 in IEEE Transactions on Applied Superconductivity
From the applications' point of view, the advantage of low density given by MgB 2 material must be taken into consideration, and the generation of strong magnetic flux densities using MgB 2 should be investigated. In this paper, we have studied the magnetic properties of samples processed by a fast spark plasma sintering machine that is able to produce dense and high-quality MgB 2 samples. Experiments were carried out both on small pieces of the samples and on large-sized samples performing trapped field measurements in a field-cooling process. For temperatures between 10 and 30 K, the results show a strong dependence of the magnetic behavior of the large-sized samples to the applied magnetic field sweep rate, whereas nothing particular appeared on the small samples. As the magnetic flux density produced by MgB 2 bulks is directly linked to the potential of the applications, we report on the field produced at the surface of one single MgB 2 sample of 30-mm diameter and the field produced inside a stack of two MgB 2 samples of 20-mm diameter. A generation of magnetic flux density (magnetic polarization μ 0 M) up to 4.80 T at 10 K and 3.92 T at 20 K inside the stack of the two MgB 2 samples was observed under a negative supporting field of -1.47 and -1.95 T, respectively. According to these values to their very low density and to their ease of manufacturing, MgB 2 bulks are promising materials for the applications of superconductors.
13 June 2005 in IEEE Transactions on Applied Superconductivity
This paper describes the design of a new kind HTS motor. Superconducting plates used as magnetic screen that cause a spatial variation of the flux density. It is theoretically possible to obtain an air gap flux density variation greater than 3 T. We perform a dimensionless study of the device showing that the torque depends on shape parameters and is limited by the maximum field on the superconducting wire. In the last section, we discuss the performance of the device in term of torque density.
5 December 2013 in Journal of Superconductivity and Novel Magnetism