The structural characteristics of expansive soil is susceptible to repeated drying and wetting cycles caused by seasonal periodical changes. In this paper, the characteristics of Nanning expansive soil were studied, and the soil–water characteristic curves of Nanning expansive soil under multiple drying and wetting cycles were obtained by adopt several known equations. Furthermore, a new prediction model considering two factors was proposed basing on the Van Genuchten model. The new model overcomes the shortcomings of the previous model which considers only matrix suction. It can reasonably consider 2 factors including the matrix suction and the number of drying and wetting cycles. The model can establish a general equation for the soil–water characteristic curve with the same fitting parameters in comparison with the previous model, which can greatly reduce workload of the measurement. In addition, the application of the improved model was broadened by comparing the fitting results and test data of expansive soils of Nanyang and volcanic ash soil.
This study aims to solve the problem of stability of the excavation surface of a new tunnel crossing an existing tunnel orthogonally. The relative horizontal spacing between the two tunnels is taken as an influencing factor, and transparent soil model tests are conducted and expanded with numerical simulations. Finally, the active destabilization mechanism and influence characteristics of the excavation surface of the two tunnels at different horizontal spacings, vertical spacings, and tunnel diameter ratios are obtained. The results show that when the excavated face is destabilized, the existing tunnel located in front of and above the excavation surface limits the development of the upper “silo” and the transfer of soil stress in the destabilized area, and the ultimate support pressure is reduced by 17.6% and 8.7%, respectively. This effect increases as the vertical spacing between the two tunnels decreases and the tunnel diameter ratio increases. At this point, the deformation trend of the existing tunnel cross-section is reflected as “elliptical-shaped”. This trend is more apparent when the vertical spacing between the two tunnels and the tunnel diameter ratio are decreased. The protection of the existing tunnel should be strengthened at this time.
To efficiently and accurately predict the effects of twin tunneling on adjacent buried pipelines, the effects of upward and downward relative pipeline‐soil interactions were considered. A series of numerical parametric studies encompassing 8640 conditions were performed to investigate the responses of a pipeline to twin tunneling. Based on the dimensionless analysis and normalized calculation results, the concept of equivalent relative pipeline‐soil stiffness was proposed. Additionally, expressions for the relative pipeline‐soil stiffness and relative pipeline curvature and for the relative pipeline‐soil stiffness and relative pipeline settlement were established, along with the related calculation plots. Relying on a comparison of prediction results, centrifuge model test results, and field measured results, the accuracy and reliability of the obtained expressions for predicting the bending strain and settlement of adjacent buried pipelines caused by twin tunneling were validated. Based on the calculation method, the maximum bending strain and maximum settlement of pipelines can be calculated precisely when the pipeline parameters, burial depth, soil parameters, and curve parameters of ground settlement due to tunneling are provided. The proposed expressions can be used not only to predict the maximum bending strain and maximum settlement of pipelines caused by single and twin tunneling but also to evaluate the effects of single and twin tunneling on the safety of existing buried pipelines. The relevant conclusions of this article can also provide a theoretical basis for the normal service of buried pipelines adjacent to subway tunnels.
Tunnel excavation inevitably results in ground movements and changes in soil stress, leading to additional stress on and settlement of nearby buried pipelines. This article focuses on the response of jointed pipelines to twin tunnelling. The relationship between the relative pipe‐soil displacement and the relative pipe‐soil stiffness was first determined. Based on this analysis, a series of numerical parametric studies encompassing 7776 conditions were performed to investigate the responses of a jointed pipeline to twin tunnelling. The results are used to estimate a regression equation for the relationship between the relative pipe‐soil stiffness and the normalized maximum joint rotation angle. This equation can be used for the direct calculation of the maximum joint rotation angle that will result from single or twin tunnelling and for the assessment of the tunnelling‐induced risk to jointed pipelines. The applicability and reliability of the regression equation are validated by comparing the calculated values with the results of earlier centrifuge tests.