Truss size and topology optimization problems have recently been solved mainly by many different metaheuristic methods, and these methods usually require a large number of structural analyses due to their mechanism of population evolution. A branched multipoint approximation technique has been introduced to decrease the number of structural analyses by establishing approximate functions instead of the structural analyses in Genetic Algorithm (GA) when GA addresses continuous size variables and discrete topology variables. For large-scale trusses with a large number of design variables, an enormous change in topology variables in the GA causes a loss of approximation accuracy and then makes optimization convergence difficult. In this paper, a technique named the label–clip–splice method is proposed to improve the above hybrid method in regard to the above problem. It reduces the current search domain of GA gradually by clipping and splicing the labeled variables from chromosomes and optimizes the mixed-variables model efficiently with an approximation technique for large-scale trusses. Structural analysis of the proposed method is extremely reduced compared with these single metaheuristic methods. Numerical examples are presented to verify the efficacy and advantages of the proposed technique.
The traditional series-type satellite vibration suppression scheme significantly decreases satellite frequency, which leads to difficulty in controlling the amplitude. In the present work, a new parallel viscous damping scheme is adopted on the Payload Adaptor Fitting (PAF), which aims to integrate a load-bearing design and vibration reduction. The vibration amplitude and weight are the most important design requirements of the damping system. The Finite Element (FE) model of PAF was established. Through a series of analyses, the appropriate number and coefficient of dampers were determined. The damping force was calculated according to the damping coefficient and the relative velocity between the two ends of the damper. Based on the damping force and the installation dimensions, the damping rod was designed. The force–velocity test was carried out on the damping rod prototype, which showed its performance satisfies the requirements. With the topology optimization and sizing optimization technology, the light-weight supports were designed and manufactured. One damping rod and two supports were assembled as one set of dampers. Eight sets of dampers were installed on the PAF. Vibration tests were conducted on the damping state PAF. The results showed that the proposed system is effective at suppressing vibration and maintaining stiffness simultaneously.