The traditional series-type satellite vibration suppression scheme significantly decreases satellite frequency, which leads to difficulty in controlling the amplitude. In the present work, a new parallel viscous damping scheme is adopted on the Payload Adaptor Fitting (PAF), which aims to integrate a load-bearing design and vibration reduction. The vibration amplitude and weight are the most important design requirements of the damping system. The Finite Element (FE) model of PAF was established. Through a series of analyses, the appropriate number and coefficient of dampers were determined. The damping force was calculated according to the damping coefficient and the relative velocity between the two ends of the damper. Based on the damping force and the installation dimensions, the damping rod was designed. The force–velocity test was carried out on the damping rod prototype, which showed its performance satisfies the requirements. With the topology optimization and sizing optimization technology, the light-weight supports were designed and manufactured. One damping rod and two supports were assembled as one set of dampers. Eight sets of dampers were installed on the PAF. Vibration tests were conducted on the damping state PAF. The results showed that the proposed system is effective at suppressing vibration and maintaining stiffness simultaneously.
Traditional optimization methods, which take a specific order of modal frequency as the design constraint, could fail to obtain the desired solution because of modal substitution. An improved optimization model with continuous sizing variables is established to solve this problem, in which the minimum weight and a given local modal frequency are considered as the objective and the constraint. To capture accurately the expected mode of vibration, a local mode identification technique is proposed based on the strain energy ratio between the local area and the whole structure. With that scheme, an optimization system is developed, in which the local mode can be effectively identified and the constraint can be updated with it in the iteration process. Two numerical examples, of a reinforced plate and a satellite structure, are applied to illustrate the effectiveness and efficacy of the proposed method.