This paper presents a low-pass filter (LPF) for an ultra-high frequency (UHF) radio frequency identification (RFID) reader transmitter in standard SMIC 0.18 μm CMOS technology. The active-RC topology and Butterworth approximation function are employed mainly for high linearity and high flatness respectively. Two cascaded fully-differential Tow-Thomas biquads are chosen for low sensitivity to process errors and strong resistance to the imperfection of the involved two-stage fully-differential operational amplifiers. Besides, the LPF is programmable in order to adapt to the multiple data rate standards. Measurement results show that the LPF has the programmable bandwidths of 605/870/1020/1330/1530/2150 kHz, the optimum input 1dB compression point of −7.81 dBm, and the attenuation of 50 dB at 10 times cutoff frequency, with the overall power consumption of 12.6 mW from a single supply voltage of 1.8 V. The silicon area of the LPF core is 0.17 mm2.
A high-speed programmable frequency divider for a Ka-band phase-locked loop (PLL)-type frequency synthesizer system is presented and fabricated in 90 nm CMOS technology. It consists mainly of a divided-by-8/9 dual-modulus prescaler (DMP) and pulse swallow counters. An active-inductor-based source-coupled logic (SCL) D flip-flop (DFF) and the “OR” gate are used in the DMP in order to promote its locking range and operation frequency. The measured operation frequency range of the improved programmable frequency divider covers from 6 to 20 GHz with a low phase noise of less than −136 dBc/Hz at a 1 MHz offset of output signals, an optimum sensitivity of −27 dBm at 15 GHz, and a low power consumption of 9.1 mW.
A high-performance inductorless ring VCO with wide tuning range and extended monotonic tuning voltage range (MTVR) is proposed and fabricated in standard 0.18μm CMOS technology. By combining the crossing-strength-tuning and load-resistance-tuning techniques with opposite tuning characteristics, the MTVR for the proposed VCO can be widened significantly. The dual-delay path technique is employed to improve the oscillating frequency. The cross-coupled pair is added to reduce phase noise and guarantee reliable differential-mode oscillation over the wide tuning voltage range. With an occupied area of 475µm×275µm and a single supply voltage of 1.8V, measurement results show the proposed VCO can oscillate with a frequency range from 1.57 to 2.76GHz, phase noise of -91.12dBc/Hz @ 1MHz and FOMT of 164.5 dBc/Hz @ 1MHz and extended MTVR.