Renjing Huang

Mr. Renjing Huang

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 February 2022 in Nature Catalysis
Verified
Journal Article
Closed access
PDF file
JFJiayi Fu
Jiayi Fu
SLShizhong Liu
Shizhong Liu
WZWeiqing Zheng
Weiqing Zheng
RHRenjing Huang
Renjing Huang
CWCong Wang
Cong Wang
DVDionisios Vlachos
Dionisios Vlachos

1 June 2021 in Journal of Catalysis
Verified
Journal Article
Closed access
RHRenjing Huang
Renjing Huang
OKOhhun Kwon
Ohhun Kwon
Chao LinChao Lin
Chao Lin
RGRaymond J. Gorte
Raymond J. Gorte

30 January 2020 in Nanomaterials
Verified
Journal Article
Open access
PDF file
RHRenjing Huang
Renjing Huang
YCYuan Cheng
Yuan Cheng
YJYichen Ji
Yichen Ji
Raymond J. GorteRaymond J. Gorte
Raymond J. Gorte
Unlike Co clusters, isolated Co atoms have been shown to be selective for catalytic dehydrogenation of ethane to ethylene; however, preparation of isolated Co sites requires special preparation procedures. Here, we demonstrate that Atomic Layer Deposition (ALD) of tris(2,2,6,6-tetramethyl-3,5-heptanedionato)cobalt(III) (Co(TMHD)3) on silica and other supports is effective in producing these isolated species. Silica-supported catalysts prepared with one ALD cycle showed ethylene selectivities greater than 96% at 923 K and were stable when CO2 was co-fed with the ethane. Co catalysts prepared by impregnation formed clusters that were significantly less active, selective, and stable. Rates and selectivities also decreased for catalysts with multiple ALD cycles. Isolated Co catalysts prepared on Al2O3 and MgAl2O4 showed reasonable selectivity for ethane dehydrogenation but were not as effective as their silica counterpart.

7 February 2022 in Journal of Catalysis
Verified
Journal Article
Closed access
OKOhhun Kwon
Ohhun Kwon
AFAlexandre C. Foucher
Alexandre C. Foucher
RHRenjing Huang
Renjing Huang
ESEric A. Stach
Eric A. Stach
JVJohn M. Vohs
John M. Vohs
RGRaymond J. Gorte
Raymond J. Gorte

31 December 2021 in Fuel
Verified
Journal Article
Closed access
TCTianyu Cao
Tianyu Cao
WLWooJae Lee
WooJae Lee
RHRenjing Huang
Renjing Huang
RGRaymond J. Gorte
Raymond J. Gorte
JVJohn M. Vohs
John M. Vohs

12 January 2023 in ChemRxiv
Verified
Preprint
Open access
PDF file
ESEli Stavitski
Eli Stavitski
SYShengsong Yang
Shengsong Yang
DRDaniel J. Rosen
Daniel J. Rosen
RHRenjing Huang
Renjing Huang
JPJun Beom Pyo
Jun Beom Pyo
ESEric A. Stach
Eric A. Stach
We report a synthesis method for highly monodisperse Cu-Pt alloy nanospheres. Small and large Cu-Pt particles with a Cu:Pt ratio of 1:1 can be obtained through colloidal synthesis at 300 °C. The fresh particles have a Pt-rich surface and a Cu-rich core and can be converted into an intermetallic phase after annealing at 800 °C under H2. First, we demonstrated the stability of fresh particles under redox conditions at 400 °C, as the Pt-rich surface prevents substantial oxidation of Cu. Then, a combination of in situ scanning transmission electron microscopy, in situ X-ray absorption spectroscopy, and CO oxidation measurements of the intermetallic CuPt phase before and after redox treatments at 800 °C showed promising activity and stability for CO oxidation. Full oxidation of Cu was prevented after exposure to O2 at 800 °C. The activity and structure of the particles was only slightly changed after exposure to O2 at 800 °C and were recovered after re-reduction at 800 °C. Additionally, the intermetallic CuPt phase showed enhanced catalytic properties compared to the fresh particles with a Pt-rich surface or pure Pt particles of the same size. Thus, the incorporation of Pt with Cu does not lead to a rapid deactivation and degradation of the material, as seen with other bimetallic systems. This work provides a synthesis route to control the design of Cu-Pt nanostructures and underlines the promising properties of these alloys (intermetallic and non-intermetallic) for heterogeneous catalysis.