The paper presents investigation results for obtaining a semi-finished product in the form of round Al-Cu bimetallic bars by the explosion method. The systems and technological parameters of explosion welding were selected in such a manner as to obtain finished bimetallic bars of an outer diameter of approx. 22 mm and a copper area fraction of the bimetal cross-section of approx. 15 and 30%. In this work was made an analysis of microstructure changes and the microhardness distribution on the cross-sections of the stock materials. There were also made tests of layers connections quality by determining the maximum shear stress on the joint boundary. The results show that the explosive cladding method guarantee a permanent connection of copper layers and aluminum core.

The paper presents the results of the study aimed at determination of plasticity of hard-deformed aluminium alloy grade 5019 in terms of parameters characteristic for the process of extrusion. The examinations were carried out in hot torsion test. Using the developed mathematical model of the analyzed alloy the mathematical modelling of torsion test was also performed.

This work presents the results of the numerical and physical modelling of the hot torsion of a hardly deformable 5XXX series aluminium alloy. Studies were conducted on constrained torsion with the use of the STD 812 torsion plastometer. The main purpose of the numerical tests was to determine the influence of the accuracy of the mathematical model describing the changes in the yield stress of the tested material on the distribution of strain parameters and on the stress intensity. According to the preliminary studies, in the case of numerical modelling of the torsion test, the accuracy of the applied mathematical model describing the changes in the rheological properties of the tested material and the correct definition of the initial and boundary conditions had a particularly significant impact on the correctness of the determination of the strain parameters and the intensity of stresses. As part of the experimental tests, physical modelling of the hot torsion test was conducted. The aim of this part of the work was to determine the influence of the applied strain parameters on the distribution and size of grain as well as the microhardness of the tested aluminium alloy. Metallographic analyses were performed using light microscopy and the electron backscatter diffraction method. Due to the large inhomogeneity of the deformation parameters and the stress intensity in the torsion test, such tests were necessary for the correct determination of the so-called representative area for metallographic analyses. These types of studies are particularly important in the case of the so-called complex deformation patterns. The paper also briefly presents the results of preliminary research and future directions in which it is planned to use complex deformation patterns for physical modelling of selected processes combining various materials.

Metallic charge heating before rolling process is very important stage of technological process of bars rolling in continuous rolling mills. Achieve of requires metallic charge temperature and permissible temperature difference on its length d...

This paper presents the results of the study aimed at determination of plasticity of selected grades of hard-deformed aluminium alloys of 5xxx series in terms of parameters characteristic for the process of extrusion. The examinations were carried out for 5083 and 5754 alloys in the torsion test using STD 812 torsion plastometer. Using the empirical tests, the study evaluated yield stress of alloys depending on strain, strain rate and temperature and the results were approximated and mathematical models of rheological properties of the aluminium grades studied were determined within the range of parameters of deformation and temperature.