myeongcheol shin

Mr. myeongcheol shin

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 January 2020 in Materials
Verified
Journal Article
Open access
PDF file
SMSeong-Ji Min
Seong-Ji Min
MSmyeongcheol shin
myeongcheol shin
NTNgoc Nguyen Thi
Ngoc Nguyen Thi
JOJong-Min Oh
Jong-Min Oh
SKSang-Mo Koo
Sang-Mo Koo
Schottky diode-based temperature sensors are the most common commercially available temperature sensors, and they are attracting increasing interest owing to their higher Schottky barrier height compared to their silicon counterparts. Therefore, this paper presents a comparison of the thermal sensitivity variation trend in temperature sensors, based on dual 4H-SiC junction barrier Schottky (JBS) diodes and Schottky barrier diodes (SBDs). The forward bias current–voltage characteristics were acquired by sweeping the DC bias voltage from 0 to 3 V. The dual JBS sensor exhibited a higher peak sensitivity (4.32 mV/K) than the sensitivity exhibited by the SBD sensor (2.85 mV/K), at temperatures ranging from 298 to 573 K. The JBS sensor exhibited a higher ideality factor and barrier height owing to the p–n junction in JBS devices. The developed sensor showed good repeatability, maintaining a stable output over several cycles of measurements on different days. It is worth noting that the ideality factor and barrier height influenced the forward biased voltage, leading to a higher sensitivity for the JBS device compared to the SBD device. This allows the JBS device to be suitably integrated with SiC power management and control circuitry to create a sensing module capable of working at high temperatures.

8 March 2021 in Materials
Verified
Journal Article
Open access
PDF file
MSmyeongcheol shin
myeongcheol shin
YLYoung-Jae LEE
Young-Jae LEE
DKDong-Hyeon Kim
Dong-Hyeon Kim
SJSeung-Woo Jung
Seung-Woo Jung
MSMichael A. Schweitz
Michael A. Schweitz
SKSang-Mo Koo
Sang-Mo Koo
In this study, static induction transistors (SITs) with beta gallium oxide (β-Ga2O3) channels are grown on a p-epi silicon carbide (SiC) layer via radio frequency sputtering. The Ga2O3 films are subjected to UV/ozone treatment, which results in reduced oxygen vacancies in the X-ray photoelectron spectroscopy data, lower surface roughness (3.51 nm) and resistivity (319 Ω·cm), and higher mobility (4.01 cm2V−1s−1). The gate leakage current is as low as 1.0 × 10−11 A at VGS = 10 V by the depletion layer formed between n-Ga2O3 and p-epi SiC at the gate region with a PN heterojunction. The UV/O3-treated SITs exhibit higher (approximately 1.64 × 102 times) drain current (VDS = 12 V) and on/off ratio (4.32 × 105) than non-treated control devices.

2 February 2021 in Materials
Verified
Journal Article
Open access
PDF file
SJSeung-Woo Jung
Seung-Woo Jung
MSmyeongcheol shin
myeongcheol shin
MSMichael A. Schweitz
Michael A. Schweitz
JOJong-Min Oh
Jong-Min Oh
SKSang-Mo Koo
Sang-Mo Koo
In this study, the physical and electrical characteristics of an AlN/4H-SiC Schottky barrier diode-based temperature sensor annealed in various gas atmospheres were investigated. An aluminum nitride (AlN) thin film was deposited on a 4H-SiC substrate via radio-frequency sputtering followed by annealing in N2 or O2 gas. The chemical composition of the film was determined by X-ray photoelectron spectroscopy (XPS) before and after annealing, and its electrical properties were evaluated by plotting a current–voltage (I–V) curve. The voltage–temperature (V–T) characteristics of the sensor were extracted from the current–voltage–temperature (I–V–T) plots constructed in the temperature range between 475 and 300 K in steps of 25 K. Sensitivities of 9.77, 9.37, and 2.16 mV/K were obtained for the as-grown, N2-annealed, and O2-annealed samples, respectively.