When a freely suspended liquid film ruptures, it retracts spontaneously under the action of surface tension. If the film is surrounded by air, the retraction velocity is known to approach the constant Taylor–Culick velocity. However, when surrounded by an external viscous medium, the dissipation within that medium dictates the magnitude of the retraction velocity. In the present work, we study the retraction of a liquid (water) film in a viscous oil ambient (two-phase Taylor–Culick retractions), and that sandwiched between air and a viscous oil (three-phase Taylor–Culick retractions). In the latter case, the experimentally measured retraction velocity is observed to have a weaker dependence on the viscosity of the oil phase as compared with the configuration where the water film is surrounded completely by oil. Numerical simulations indicate that this weaker dependence arises from the localization of viscous dissipation near the three-phase contact line. The speed of retraction only depends on the viscosity of the surrounding medium and not on that of the film. From the experiments and the numerical simulations, we reveal unprecedented regimes for the scaling of the Weber number ${We}_{f}$ of the film (based on its retraction velocity) or the capillary number ${Ca}_{s}$ of the surroundings versus the Ohnesorge number ${Oh}_{s}$ of the surroundings in the regime of large viscosity of the surroundings ( ${Oh}_{s} \gg 1$ ), namely ${We}_{f} \sim {Oh}_{s}^{-2}$ and ${Ca}_{s} \sim {Oh}_{s}^{0}$ for the two-phase Taylor–Culick configuration, and ${We}_{f} \sim {Oh}_{s}^{-1}$ and ${Ca}_{s} \sim {Oh}_{s}^{1/2}$ for the three-phase Taylor–Culick configuration.
Long and slender liquid filaments are produced during inkjet printing, which can subsequently either retract to form a single droplet, or break up to form a primary droplet and one or more satellite droplets. These satellite droplets are undesirable since they degrade the quality and reproducibility of the print, and lead to contamination within the enclosure of the print device. Existing strategies for the suppression of satellite droplet formation include, among others, adding viscoelasticity to the ink. In the present work, we aim to improve the understanding of the role of viscoelasticity in suppressing satellite droplets in inkjet printing. We demonstrate that very dilute viscoelastic aqueous solutions ( $\text {concentrations} \sim 0.003\,\%$ wt. polyethylene oxide, corresponding to nozzle Deborah number $De_{n}\sim 3$ ) can suppress satellite droplet formation. Furthermore, we show that, for a given driving condition, upper and lower bounds of polymer concentration exist, within which satellite droplets are suppressed. Satellite droplets are formed at concentrations below the lower bound, while jetting ceases for concentrations above the upper bound (for fixed driving conditions). Moreover, we observe that, with concentrations in between the two bounds, the filaments retract at velocities larger than the corresponding Taylor–Culick velocity for the Newtonian case. We show that this enhanced retraction velocity can be attributed to the elastic tension due to polymer stretching, which builds up during the initial jetting phase. These results shed some light on the complex interplay between inertia, capillarity and viscoelasticity for retracting liquid filaments, which is important for the stability and quality of inkjet printing of polymer solutions.
25 September 2017 in Combustion Science and Technology