High heat input during welding leads to transformations of the microstructure in the area subjected to welding, mostly resulting in an inhomogeneous microstructure and an overall deterioration of the mechanical properties. To restore these properties, post treatment processes which are typically separated from the welding process are state of the art. The present work focusses on recrystallization phenomena and shows the new methodology, WeldForming, which intends to eliminate subsequent treatment processes. The new inline process combination harnesses the synergies of a welding and a rolling process to ultimately prevent the typical zone formation of the heat affected zone. This is done by stimulating recrystallization and recovery processes. The development of the process is based on numerical simulations. A new aspect is the first time coupling of both processes in a single simulation model. The required material models were generated with the aid of thermophysical simulations. A novel approach is shown for creating a material model for the filler metal G4Si1 with the typical directed solidification microstructure. On the basis of the gained knowledge out of thermomechanical and numerical simulation, a process window was identified and a test setup was developed which gave the functional prove of the WeldForming process.
The high heat input during fusion welding leads to transformations of the microstructure in the area subjected to welding, mostly resulting in a heterogene crystalline structure and an overall deterioration of the mechanical properties. To reduce the detrimental effect, posttreatment processes which are typically separated from the actual welding process are state of the art. The present work shows the new methodology, WeldForming, which intends to eliminate subsequent treatment processes. The new in-line process combination harnesses the synergies of a welding and a rolling process to ultimately prevent the typical zone formation of the heat affected zone. Experimental investigations combined with a detailed numerical simulation of the coupled welding and forming process indicate the functional proof of the new methodology. The validation of the numerical model is carried out with the aid of temperature profiles, cross sections, and microstructure analysis as well as flow curves determined by upsetting tests on thermomechanical simulation systems.
Wire-arc directed energy deposition (WA-DED) using dynamic multi-axis hardware is typically restricted to a neutral position (90°), limiting process flexibility and full exploitation of multi-axis capabilities. To unlock torch positioning and stick-out distance as levers for tailored process manipulation, this study examines energy distribution across 124 samples using ER70S-6 filler wire. A 6 × 6 process window spanning wire feed speed (WFS = 2–7 m/min) and travel speed (v = 400–900 mm/min) was evaluated alongside continuous stick-out ramps (5–35 mm) and ten torch inclinations in push (45°, 60°, 75°), neutral (90°), drag (105°, 120°, 135°), and lateral (L15°, L30°, L45°) orientations. A synchronized multi-sensor framework captured electrical, thermographic, and melt pool dynamics while integrating airborne sound acoustic monitoring of process instabilities. Metallographic cross-sections, microhardness mapping, and EBSD grain analysis indicated microstructural shifts. Across the parameter matrix, volumetric energy density (VED) remained within 19–23 J/mm3 (measured), while thermal tracking revealed progressive heat accumulation. Stick-out extensions reduced heat input by 1.1–1.5%/mm, raising peak hardness in single beads from 290–310 HV to 350–385 HV. Torch orientation redistributed thermal energy at nearly constant heat and mass input. In the walls tested, melt pool length shifted by up to 30% and mean grain size by 11.1%, and penetration depth followed the push to drag sequence. Short-circuit frequency and cycle-period variation mirrored the approach to the humping limit, and acoustic envelope statistics accompanied overmelting. Thus, torch orientation and stick-out provide sensor-observable levers to influence process dynamics and component properties.