We report the results of the search for dark photons with mass around using a multilayer dielectric haloscope equipped with an affordable and commercially available photosensor. The multilayer stack, which enables the conversion of dark photons (DP) to Standard Model photons, is made of 23 bilayers of alternating and thin films with linearly increasing thicknesses through the stack (a configuration known as a “chirped stack”). The thicknesses have been chosen according to an optimization algorithm in order to maximize the DP-photon conversion in the energy region where the photosensor sensitivity peaks. This prototype experiment, dubbed “MuDHI” (Multilayer Dielectric Haloscope Investigation) by the authors of this paper, has been designed, developed, and run at the Astroparticle Laboratory of New York University Abu Dhabi, which marks the first time a dark matter experiment has been operated in the Middle East. No significant signal excess is observed, and the method of maximum log likelihood is used to set exclusion limits at 90% confidence level on the kinetic mixing coupling constant between dark photons and ordinary photons.
Superconducting transition-edge sensors (TESs) are a type of quantum sensor known for their high single-photon detection efficiency and low background. This makes TESs ideal for particle-physics experiments searching for rare events. In this work, we present a comprehensive characterization of the background in optical TESs, distinguishing three types of events: electrical-noise, high-energy, and photonlike events. We introduce computational methods to automate the classification of events. We experimentally verify and simulate the source of the high-energy events. We also isolate the photonlike events, the expected signal in dielectric haloscopes searching for dark-matter dark photons, and achieve a photonlike dark-count rate of 3.6× in the 0.8–3.2 eV energy range.
In this paper a microscopic, non-discrete, mathematical model based on stigmergy for predicting the nodal aggregation dynamics of decentralized, autonomous robotic swarms is proposed. The model departs from conventional applications of stigmergy in bioinspired path-finding optimization, serving as a dynamic aggregation algorithm for nodes with limited or no ability to perform discrete logical operations, aiding in agent miniaturization. Time-continuous simulations were developed and carried out where nodal aggregation efficiency was evaluated using the following metrics: time to aggregation equilibrium, agent spatial distribution within aggregate (including average inter-nodal distance, center of mass of aggregate deviation from target), and deviation from target agent number. The system was optimized using cost minimization of the above factors through generating a random set of cost datapoints with varying initial conditions (number of aggregates, agents, field dimensions, and other specific agent parameters) where the best-fit scalar field was obtained using a random forest ensemble learning strategy and polynomial regression. The scalar cost field global minimum was obtained through basin-hopping with L-BFGS-B local minimization on the scalar fields obtained through both methods. The proposed optimized model describes the physical properties that non-digital agents must possess so that the proposed aggregation behavior emerges, in order to avoid discrete state algorithms aiming towards developing agents independent of digital components aiding to their miniaturization.
26 December 2022 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
An ionizing particle passing through a liquid generates acoustic signals via local heat deposition. We delve into modeling such acoustic signals in the case of a single particle that interacts with the liquid electromagnetically in a generic way. We present a systematic way of introducing corrections due to viscosity using a perturbative approach so that our solution is valid at large distances from the interaction point. A computational simulation framework to perform the calculations described is also provided. The methodology developed is then applied to predict the acoustic signal of relativistic muons in various liquids as a toy model.