9 June 2023 in Physical Review Applied
PFP. Falthansl-Scheinecker
+1
We build a parametric amplifier with a Josephson field-effect transistor (JoFET) as the active element. The resonant frequency of the device is field-effect tunable over a range of . The JoFET amplifier has of gain, of instantaneous bandwidth, and a 1-dB compression point of when operated at a fixed resonance frequency.
30 March 2022 in Physical Review D
We report the results of the search for dark photons with mass around using a multilayer dielectric haloscope equipped with an affordable and commercially available photosensor. The multilayer stack, which enables the conversion of dark photons (DP) to Standard Model photons, is made of 23 bilayers of alternating and thin films with linearly increasing thicknesses through the stack (a configuration known as a “chirped stack”). The thicknesses have been chosen according to an optimization algorithm in order to maximize the DP-photon conversion in the energy region where the photosensor sensitivity peaks. This prototype experiment, dubbed “MuDHI” (Multilayer Dielectric Haloscope Investigation) by the authors of this paper, has been designed, developed, and run at the Astroparticle Laboratory of New York University Abu Dhabi, which marks the first time a dark matter experiment has been operated in the Middle East. No significant signal excess is observed, and the method of maximum log likelihood is used to set exclusion limits at 90% confidence level on the kinetic mixing coupling constant between dark photons and ordinary photons.
15 February 1997 in Journal of Applied Physics
Optically pumped lasing from InGaN/GaN single heterojunctions (SH) was observed in an edge emitting configuration at 77 K. The heterojunctions were grown by atmospheric pressure metalorganic chemical vapor deposition on c-plane sapphire substrates. The frequency tripled output of a mode-locked titanium:sapphire laser with a pulse width of 250 fs, operating at 280 nm, was used as the photoexcitation source. The nonlinear dependence of output emission intensity on input power density, the observations of a strongly polarized output emission, and distinct Fabry–Perot modes are discussed.
5 February 2024 in Physical Review Research
Precision sensing and manipulation of milligram-scale mechanical oscillators has attracted growing interest in the fields of table-top explorations of gravity and tests of quantum mechanics at macroscopic scales. Torsional oscillators present an opportunity in this regard due to their remarked isolation from environmental noise. For torsional motion, an effective employment of optical cavities to enhance optomechanical interactions—as already established for linear oscillators—so far faced certain challenges. Here, we propose a concept for sensing and manipulating torsional motion, where exclusively the torsional rotations of a pendulum are mapped onto the path length of a single two-mirror optical cavity. The concept inherently alleviates many limitations of previous approaches. A proof-of-principle experiment is conducted with a rigidly controlled pendulum to explore the sensing aspects of the concept and to identify practical limitations in a potential state-of-the art setup. Based on this study, we anticipate development of precision torque sensors utilizing torsional pendulums that can support sensitivities below , while the motion of the pendulums are dominated by quantum radiation pressure noise at sub-microwatts of incoming laser power. These developments will provide horizons for experiments at the interface of quantum mechanics and gravity.