Boron removal was evaluated in the present work by using calcium alginate beads (CA) and a novel composite based on alginate–alumina (CAAl) as sorbents in a batch system. The effects of different parameters such as pH, temperature, contact time, and composition of alginate (at different concentrations of guluronic and mannuronic acids) on boron sorption were investigated. The results confirm that calcium alginate beads (CA) exhibited a better adsorption capacity in a slightly basic medium, and the composite alginate–alumina (CAAl) exhibited improved boron removal at neutral pH. Sorption isotherm studies were performed and the Langmuir isotherm model was found to fit the experimental data. The maximum sorption capacities were 4.5 mmol g−1 and 5.2 mmol g−1, using CA and CAAl, respectively. Thermodynamic parameters such as change in free energy (ΔG0), enthalpy (ΔH0), and entropy (ΔS0) were also determined. The pseudo-first-order and pseudo-second-order rate equations (PFORE and PSORE, respectively) were tested to fit the kinetic data; the experimental results can be better described with PSORE. The regeneration of the loaded sorbents was demonstrated by using dilute HCl solution (distilled water at pH 3) as eluent for metal recovery.
Removal of heavy metals from wastewater is mandatory in order to avoid water pollution of natural reservoirs. In the present study, layered double hydroxide (LDH) materials were evaluated for removal of zinc from aqueous solutions. Materials thus prepared were impregnated with cyanex 272 using the dry method. These materials were characterized through X-ray diffraction (XRD), Fourier transform infrared (FTIR), and thermal analysis. Batch shaking adsorption experiments were performed in order to examine contact time and extraction capacity in the removal process. Results showed that the equilibrium time of Zn (II) extraction is about 4 h for Mg2Al-CO3 and Mg2Al-CO3-cyanex 272, 6 h for Zn2Al-CO3, and 24 h for Zn2Al-CO3-cyanex 272. The experimental equilibrium data were tested for Langmuir, and Freundlich isotherm models. Correlation coefficients indicate that experimental results are in a good agreement with Langmuir’s model for zinc ions. Pseudo-first, second-order, Elovich, and intraparticular kinetic models were used to describe kinetic data. It was determined that removal of Zn2+ was well-fitted by a second-order reaction kinetic. A maximum capacity of 280 mg/g was obtained by Zn2Al-CO3-cyanex 272.
This article presents a study of cadmium removal from nitrate medium using adsorption in calcined mesoporous silica (MCM-C), mesoporous silica doped (MCM_DIOPA), and calcined and impregnated mesoporous silica (MCM@DIOPA), with diisooctylphosphinic acid (DIOPA). The sorbents were synthesized via a sol–gel method. Several characterization techniques, such as XRD, FTIR spectroscopy, N2 sorption and elemental analysis, have been used to determine the main structural, textural, and chemical properties of prepared sorbents. Batch adsorption and kinetics tests were carried out, where the influence of pH and contact time of the sorbents and their role in cation removal were studied. Experimental results show poor sorption efficiencies with MCM-C and MCM_DIOPA at pH 5.85. At the same pH, better cadmium extraction was attained by MCM@DIOPA and was achieved within 30 min. The pseudo-second-order model is the most appropriate model to describe the elimination mechanism of Cd(II) ions. The Langmuir equation was used to model the sorption isotherm and the maximum sorption capacity of Cd(II) is 22.16 mg/g (200 mmol/kg). The complex type of the probable extracted species isCdL2-HL.