This study investigates different cases to obtain optimal Window-to-Wall ratio (WWR) in seven different climate conditions based on the Köppen–Geiger climate classification. The optimal WWR was decided based on the minimum amount of total energy use (total of cooling, heating, and lighting energy use) of a building model during a complete year. The impact of overhang and automatic blinds were assessed on the optimization of WWR for a building with integrated automatic lighting control. Moreover, three different windows with different U-values and features were employed in order to analyze their effect on the energy use and WWR of the building. IDA-Indoor Climate and Energy (IDA-ICE) was used to carry out the simulations. The software has been validated based on ASHRAE Standard 140. Based on each climate condition, orientation, employed window type, and comfort conditions, an optimal range with a specific combination of window with blind, overhang, or neither was found.
Photovoltaic (PV) panels and thermal collectors are commonly known as mature technologies to capture solar energy. The efficiency of PV cells decreases as operating cell temperature increases. Photovoltaic Thermal Collectors (PVT) offer a way to mitigate this performance reduction by coupling solar cells with a thermal absorber that can actively remove the excess heat from the solar cells to the Heat Transfer Fluid (HTF). In order for PVT collectors to effectively counter the negative effects of increased operating cell temperature, it is fundamental to have an adequate heat transfer from the cells to the HTF. This paper analyzes the operating temperature of the cells in a low concentrating PVT solar collector, by means of both experimental and Computational Fluid Dynamics (CFD) simulation results on the Solarus asymmetric Compound Parabolic Concentrator (CPC) PowerCollector (PC). The PC solar collector features a Compound Parabolic Concentrator (CPC) reflector geometry called the Maximum Reflector Concentration (MaReCo) geometry. This collector is suited for applications such as Domestic Hot Water (DHW). An experimental setup was installed in the outdoor testing laboratory at Gävle University (Sweden) with the ability to measure ambient, cell and HTF temperature, flow rate and solar radiation. The experimental results were validated by means of an in-house developed CFD model. Based on the validated model, the effect of collector tilt angle, HTF, insulation (on the back side of the reflector), receiver material and front glass on the collector performance were considered. The impact of tilt angle is more pronounced on the thermal production than the electrical one. Furthermore, the HTF recirculation with an average temperature of 35.1 °C and 2.2 L/min flow rate showed that the electrical yield can increase by 25%. On the other hand, by using insulation, the thermal yield increases up to 3% when working at a temperature of 23 °C above ambient.
17 September 2007 in Particulate Science and Technology
The airflow field and particle trajectory and deposition in a duct with a rectangular obstruction were studied. The governing conservation equations of mass and momentum were discretized using a finite volume method, and the corresponding velocity vector and pressure fields were evaluated. The particle trajectories were evaluated by solving the Lagrangian equation of motion that included the drag, Saffman's lift, and gravity forces. Effects of different forces as well as the blockage and the obstruction aspect ratios on particle trajectory and deposition were analyzed for a Reynolds number of 200. The simulation results showed that with the increase of Stokes number, particle deposition efficiency on the front side of the obstruction increased and also the presence of the gravitational force in the span-wise direction caused the particles to be deposited on the channel lower wall. The presence of gravity in the stream-wise direction increased the deposition efficiency and in the counter-stream-wise direction decreased the deposition efficiency. Changing the obstruction aspect ratio had no noticeable effect on the deposition but increasing the blockage ratio increased the deposition efficiency. The presence of a lift force had different effects for different blockage ratios and Stokes numbers. But the lift force generally increased the deposition rate, especially at large Stokes numbers and large blockage ratios.