A method which combines polymer particle assembly, chemical infiltration and etching with an aerosol assisted deposition process is described for the fabrication of 3D inverse opal (IO) structures with sub-micron periodicity and precision. This procedure not only overcomes limitations associated with slow, expensive micro-fabrication methods but also permits the tuning of refractive index contrast via the direct incorporation of photonically-active, preformed, tailored silicon nanostructures. It is demonstrated that this approach can be used to modify the photonic band gap (PBG) by effectively depositing/patterning optically active silicon nanocrystals (ncSi) onto the pore walls of a 3D inverse opal structure. This simple, yet effective method for preparing functional complex 3D structures has the potential to be used generically to fabricate a variety of functional porous 3D structures that could find application not only in new or improved photonic crystal (PC) devices but also in areas such as catalysis, separation, fuel cells technology, microelectronics and optoelectronics.
This paper investigated the effects of Pr6O11 and Co3O4 on the electrical properties of ZnO-BaTiO3 varistor ceramics. The Pr6O11 doping has a notable influence on the characteristics of the nonlinear coefficient, varistor voltage, and leakage current where the values varied from 2.29 to 2.69, 12.36 to 68.36 V/mm and 599.33 to 548.16 µA/cm2, respectively. The nonlinear varistor coefficient of 5.50 to 7.15 and the varistor voltage of 7.38 to 8.10 V/mm was also influenced by the use of Co3O4 as a dopant. When the amount of Co3O4 was above 0.5 wt.%, the leakage current increased from 202.41 to 302.71 μA/cm2. The varistor ceramics with 1.5 wt.% Pr6O11 shows good nonlinear electrical performance at higher breakdown voltage and reduced the leakage current of the ceramic materials. Besides, the varistor sample that was doped with 0.5 wt.% Co3O4 was able to enhance the nonlinear electrical properties at low breakdown voltage with a smaller value of leakage current.
26 November 2014 in Applied Mechanics and Materials
The bottom-up colloidal synthesis of photonic band gap (PBG) materials or photonic crystals (PC) has attracted considerable interest as compared to so-called top-down lithographic approaches due to the simple processing steps involved and the prospect of the economically viable production of complex 3-dimensional optical materials from simple colloidal particles. To date self-assembly techniques constitute the most popular approach to fabricate 3D photonic crystals from colloidal particle suspensions. Based on the natural tendency of monodisperse colloidal particles to organise into ordered arrays, this method represent the best option due to the ease of fabrication, ability to produce larger area samples and cost. Here we report on the fabrication of long range three-dimensional (3D) ordered poly (methyl methacrylate) (PMMA)-silica PC structures and the subsequent fabrication of robust silica inverse opals using self-assembly methods. The optical properties of these materials are described and discussed in terms of potential applications of these materials.
31 October 2018 in IOP Conference Series: Materials Science and Engineering