The quality assurance of the two Brewer spectrophotometers of the Finnish Meteorological Institute is discussed in this paper. The complete data processing chain from raw signal to high quality spectra is presented. The quality assurance includes daily maintenance, laboratory characterizations, calculation of long-term spectral responsivity, data processing and quality assessment. The cosine correction of the measurements is based on a new method, and is included in the data processing software. The results showed that the actual cosine correction factor of the two Finnish Brewers can vary between 1.08–1.13 and 1.08–1.12, respectively, depending on the sky radiance distribution and wavelength. The temperature characterization showed a linear temperature dependence between the instruments' internal temperature and the photon counts per cycle, and a temperature correction was used for correcting the measurements. The long-term spectral responsivity was calculated using the time series of several lamps using two slightly different methods. The long-term spectral responsivity was scaled to the irradiance scale of the Helsinki University of Technology (HUT) for the whole of the measurement time-periods 1990–2006 and 1995–2006 for Sodankylä and Jokioinen, respectively. Both Brewers have participated in many international spectroradiometer comparisons, and have shown good stability. The differences between the Brewers and the portable reference spectroradiometer QASUME have been within 5% during 2002–2007.
4 December 2007 in Journal of Geophysical Research: Atmospheres
Review of the existing bibliography shows that the direction and magnitude of the long-term trends of UV irradiance, and their main drivers, vary significantly throughout Europe. Analysis of total ozone and spectral UV data recorded at four European stations during 1996–2017 reveals that long-term changes in UV are mainly driven by changes in aerosols, cloudiness, and surface albedo, while changes in total ozone play a less significant role. The variability of UV irradiance is large throughout Italy due to the complex topography and large latitudinal extension of the country. Analysis of the spectral UV records of the urban site of Rome, and the alpine site of Aosta reveals that differences between the two sites follow the annual cycle of the differences in cloudiness and surface albedo. Comparisons between the noon UV index measured at the ground at the same stations and the corresponding estimates from the Deutscher Wetterdienst (DWD) forecast model and the ozone monitoring instrument (OMI)/Aura observations reveal differences of up to 6 units between individual measurements, which are likely due to the different spatial resolution of the different datasets, and average differences of 0.5–1 unit, possibly related to the use of climatological surface albedo and aerosol optical properties in the retrieval algorithms.
Spectrometers are designed to isolate particular wavebands and suppress light from wavelengths outside the band of interest. However, a small amount of undesired light will always enter the detector, not through the designed optical path, but through random scattering from the instrument optical components, housing, and dust particles. Every spectrophotometer has stray light coming from outside the nominal measurement waveband. For Dobson spectrophotometers and single monochromator Brewer spectrophotometers, which are basic instruments in the World Meteorological Organization (WMO) ozone and ultraviolet (UV) monitoring network, the error introduced by stray light is substantial when the ozone slant path becomes very large because of high solar zenith angles and a thick ozone layer. These are common conditions during Arctic spring. To study the issue, a long ozone slant path Intercomparison/Calibration campaign for Nordic Brewers and Dobsons was held at Sodankylä 8–24 March 2011 and a follow-up campaign to extend calibrations to shorter ozone slant paths took place at Izaña observatory, Tenerife, between 28 October and 18 November 2011. These campaigns were part of the Committee on Earth Observation Satellites (CEOS) Intercalibration of Ground-based Spectrometers and Lidars project funded by the European Space Agency (ESA), intended to permit the homogenization of ozone data from the European ozone ground-truthing network. During the active intercomparison periods, measurements were taken only when good conditions for sun or moon observations existed. Laboratory measurements using calibration lamps and helium-cadmium (HeCd) lasers were an essential part of both campaigns. The campaigns produced a high-quality database of total ozone and UV measurements and an accurate, up-to-date calibration and characterization of participating Brewers and Dobsons against the European standard instruments from the Regional Dobson Calibration Centre-Europe (RDCC-E) and the Regional Brewer Calibration Centre-Europe (RBCC-E). In the present work we focus on single monochromator Brewers and present a physics-based method to compensate for the stray-light effects in ozone retrieval using laboratory characterizations and radiative transfer modelling. The method was tested with independent data from the campaign.