2,4,6-trinitrotoluene (TNT) is widely used in conventional and insensitive munitions as a fusible binder, commonly melt-cast with other explosives such as 1,3,5-trinitroperhydro-1,3,5-triazine (RDX) or 3-nitro-1,2,4-triazol-one (NTO). In this paper, we study the shock-to-detonation transition phenomenon in two melt-cast high explosives (HE). We have performed plate impact tests on wedge samples to measure run-distance and time-to-detonation in order to establish the Pop-plot relation for several melt-cast HE. Highlighting the existence of the single curve buildup, we propose a two phase model based on a Zeldovich, Von-Neumann, Döring (ZND) approach where the deflagration fronts grow from the explosive grain boundaries. Knowing the grain size distribution, we calculate the deflagration velocities of the explosive charges as a function of shock pressure and explore the possible grain fragmentation.
Dynamic measurements of shock and detonation velocities are performed using long chirped fiber Bragg gratings (CFBGs). Such thin probes, with a diameter of typically 125 µm or even 80 µm can be directly inserted into high-explosive (HE) samples or simply glued laterally. During the detonation, the width of the optical spectrum is continuously reduced by the propagation of the wave-front, which physically shortens the CFBG. The light power reflected back shows a ramp-down type signal, from which the wave-front position is obtained as a function of time, thus yielding a detonation velocity profile. A calibration procedure was developed, with the support of optical simulations, to cancel out the optical spectrum distortions from the different optical components and to determine the wavelength-position transfer function of the CFBG. The fitted slopes of the X–T diagram give steady detonation velocity values which are in very good agreement with the classical measurements obtained from discrete electrical shorting pins (ESP). The main parameters influencing the uncertainties on the steady detonation velocity value measured by CFBG are discussed. To conclude, different HE experimental configurations tested at CEA (Commissariat à l’Energie Atomique et aux Energies Alternatives) are presented: bare cylindrical sticks, wedges for shock-to-detonation transitions (SDT), spheres, a cast-cured stick around a CFBG, and a detonation wave-front profile configuration.
In the field of shock physics and energetic materials, Fiber Bragg Gratings (FBGs) are used to measure shock velocity, detonation velocity and shock pressure levels. They are also used to measure strain in structures loaded with explosive effects. FBG sensors are known to be light, small, immune electromagnetic environments and have fast response compared to electrical sensors. To use one or more gratings along a fiber, a high-resolution spectrometer with a high sampling rate has been developed. This dynamic spectrometer employs time-multiplexing by wavelength-to-time conversion using dispersion. It provides a complete view of the spectra evolution at a rate of 100 MHz. Thus, complex phenomena can be observed. In this paper, the interrogation technique is presented in more detail, and experimental results are discussed. The experiments presented are a low-pressure shock velocity measurement in epoxy, a deflagration-to-detonation transition in a porous energetic material, a Shock-to-Detonation Transition in a dense energetic material, a tentative-to-measure pressure level in epoxy from an FBG made in a sapphire fiber and multi-point strain measurements up to eight FBGs. The advantages and limits are discussed for each type of experiment.