A capture cross section value is often assigned to Si–SiO2 interface defects. Using a kinetic variation of the charge pumping technique and transition state theory, we show that the value of capture cross section is extremely sensitive to the measurement approach and does not provide any meaningful insight into the physics involved. We argue that capture cross section is neither a physical property of interface defects nor is there any need to assign capture cross section values.
To combat the large variability problem in resistive random access memory, current compliance elements are commonly used to limit the in-rush current during the forming operation. Regardless of the compliance element (1R-1R or 1T-1R), some degree of current overshoot is unavoidable. The peak value of the overshoot current is often used as a predictive metric of the filament characteristics and is linked to the parasitic capacitance of the test structure. The reported detrimental effects of higher parasitic capacitance seem to support this concept. However, this understanding is inconsistent with the recent successes of compliance-free ultrashort pulse forming which guarantees a maximum peak overshoot current. We use detailed circuit analysis and experimental measurements of 1R-1R and 1T-1R structures to show that the peak overshoot is independent of the parasitic capacitance while the overshoot duration is strongly dependent on the parasitic capacitance. Forming control can be achieved, in ultrashort pulse forming, since the overshoot duration is always less than the applied pulse duration. The demonstrated success of ultrashort pulse forming becomes easier to reconcile after identifying the importance of overshoot duration.
The stochastic nature of the conductive filaments in oxide-based resistive memory resistive random access memory (RRAM) represents a sizeable impediment to commercialization. As such, program-verify methodologies are highly alluring. However, it was recently shown that the program-verify methods are unworkable due to strong resistance state relaxation after SET/RESET programming. In this letter, we demonstrate that resistance state relaxation is not the main culprit. Instead, it is fluctuation-induced false-reading (triggering) that defeats the program-verify method, producing a large distribution tail immediately after programming. The fluctuation impact on the verify mechanism has serious implications on the overall write/erase speed of RRAM.
1 January 2019 in Review of Scientific Instruments
We report on a novel electron paramagnetic resonance (EPR) technique that merges electrically detected magnetic resonance (EDMR) with a conventional semiconductor wafer probing station. This union, which we refer to as wafer-level EDMR (WL-EDMR), allows EDMR measurements to be performed on an unaltered, fully processed semiconductor wafer. Our measurements replace the conventional EPR microwave cavity or resonator with a very small non-resonant near-field microwave probe. Bipolar amplification effect, spin dependent charge pumping, and spatially resolved EDMR are demonstrated on various planar 4H-silicon carbide metal-oxide-semiconductor field-effect transistor (4H-SiC MOSFET) structures. 4H-SiC is a wide bandgap semiconductor and the leading polytype for high-temperature and high-power MOSFET applications. These measurements are made via both “rapid scan” frequency-swept EDMR and “slow scan” frequency swept EDMR. The elimination of the resonance cavity and incorporation with a wafer probing station greatly simplifies the EDMR detection scheme and offers promise for widespread EDMR adoption in semiconductor reliability laboratories.