Purpose: The discrete element method (DEM) can be used in agricultural fields such as crop sowing, harvesting, and crop transportation. Nevertheless, modeling complex crops as appropriately shaped particles remains challenging. The modeling of particles and the calibration of input parameters are important for simulating the realistic behaviors of particles using the DEM. Methods: In this study, particle models representing the morphological characteristics and size deviations of garlic cloves were proposed. Additionally, the coefficients of friction were analyzed as the contact parameters of the particles based on the heap formation experiments and simultations of the swing-arm method using 150 garlic cloves. Results: The simulation results were analyzed that the residual number of particles, a bulk property that can be measured simply in the experiment, is related to the coefficients of friction. In the heap formation experiments with low particle counts, the bulk properties were more clearly differentiated by the residual number of particles than the angle of repose. Moreover, the bulk properties similar to the actual garlic could not be expressed as a spherical particle model. Thus, an equation for predicting the residual number of particles was derived for the non-spherical garlic clove particle model. Five sets of coefficients of friction were presented using the prediction equation, and all the simulation results were close to the actual residual number of particles and angle of repose of the garlic. Conclusions: Although the sizes of garlic cloves have a wide distribution, appropriate inter-particle contact parameters could be predicted. Therefore, the calibration process of the DEM can be shortened using the proposed prediction equation for the residual number of particles with non-spherical particles.
3 March 2016 in Spanish Journal of Agricultural Research
The use of unmanned aerial spray systems (UASS) has increased owing to their many advantages. However, studies related to a standardized method to evaluate the spray performance of UASS are lacking. Therefore, in the present study, a quantitative analytical method using a food dye tracer was compared with the image analysis method, and the effects of experimental conditions on spray deposition were assessed. Concordance between the results of quantitative and image analyses was examined. The coverage of water-sensitive paper (WSP) and Medley Velvet (MV) was compared using image analysis. Moreover, the effects of flight altitude and collector height on spray deposition amount and effective spray width were evaluated. The results showed a significant correlation between the deposition and the coverage of MV (R2 = 0.6782, p-level < 0.001). The coverage of MV is different from that of WSP. In addition, the correlation coefficient between the coverage of WSP and that of MV was smaller than the correlation coefficient between depositions and the coverage of MV. Therefore, MV should be used instead of WSP for more accurate analysis. The lower the collector height, the smaller the deposition amount. The effective spray width increased as the distance between the collector and UASS increased, whereas the total deposition amount decreased when the collector was close to the ground. Overall, using a food dye tracer, both quantitative and qualitative analyses can be applied simultaneously, and this method may replace analysis using WSP.
Journal of Animal Science and Technology (JAST) is a peer-reviewed, open access journal publishing original research, review articles and notes in all fields of animal science. Topics covered by the journal include: genetics and breeding, physiology, nutrition of monogastric animals, nutrition of ruminants, animal products (milk, meat, eggs and their by-products) and their processing, grasslands and roughages, livestock environment, animal biotechnology, animal behavior and welfare.