Karl Ropkins

Dr. Karl Ropkins

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2021 in Science of The Total Environment
Verified
Journal Article
Closed access
Karl RopkinsKarl Ropkins
Karl Ropkins
JTJames E. Tate
James E. Tate

1 December 2017 in Science of The Total Environment
Verified
Journal Article
Open access
Karl RopkinsKarl Ropkins
Karl Ropkins
TDTimothy H. DeFries
Timothy H. DeFries
Francis PopeFrancis Pope
Francis Pope
DGDavid Green
David Green
JKJim Kemper
Jim Kemper
JHJ. Stewart Hager
J. Stewart Hager
Despite much work in recent years, vehicle emissions remain a significant contributor in many areas where air quality standards are under threat. Policy-makers are actively exploring options for next generation vehicle emission control and local fleet management policies, and new monitoring technologies to aid these activities. Therefore, we report here on findings from two separate but complementary blind evaluation studies of one new-to-market real-world monitoring option, HEAT LLC's Emission Detection And Reporting system or EDAR, an above-road open path instrument that uses Differential Absorption LIDAR to provide a highly sensitive and selective measure of passing vehicle emissions. The first study, by Colorado Department of Public Health and Environment and Eastern Research Group, was a simulated exhaust gas test exercise used to investigate the instrumental accuracy of the EDAR. Here, CO, NO, CH4 and C3H8 measurements were found to exhibit high linearity, low bias, and low drift over a wide range of concentrations and vehicle speeds. Instrument accuracy was high (R2 0.996 for CO, 0.998 for NO; 0.983 for CH4; and 0.976 for C3H8) and detection limits were 50 to 100ppm for CO, 10 to 30ppm for NO, 15 to 35ppmC for CH4, and, depending on vehicle speed, 100 to 400ppmC3 for C3H8. The second study, by the Universities of Birmingham and Leeds and King's College London, used the comparison of EDAR, on-board Portable Emissions Measurement System (PEMS) and car chaser (SNIFFER) system measurements collected under real-world conditions to investigate in situ EDAR performance. Given the analytical challenges associated with aligning these very different measurements, the observed agreements (e.g. EDAR versus PEMS R2 0.92 for CO/CO2; 0.97 for NO/CO2; ca. 0.82 for NO2/CO2; and, 0.94 for PM/CO2) were all highly encouraging and indicate that EDAR also provides a representative measure of vehicle emissions under real-world conditions.


9 September 2010
Verified
Dataset
Closed access
DCDavid Carslaw
David Carslaw
JDJack Davison
Jack Davison
Karl RopkinsKarl Ropkins
Karl Ropkins

16 October 2006 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Open access
PDF file
HLHu Li
Hu Li
Karl RopkinsKarl Ropkins
Karl Ropkins
GAGordon E Andrews
Gordon E Andrews
BDBasil Daham
Basil Daham
MBMargaret Carol Bell
Margaret Carol Bell
GHGary Hawley
Gary Hawley
A series of chassis dynamometer test trials were conducted to assess the performance of a Fourier Transform Infra Red (FTIR) system developed for on-road vehicle exhaust emissions measurements. Trials used a EURO 1 emission compliant SI passenger car which, alongside the FTIR, was instrumented to allow the routine logging of engine speed, road speed, throttle position, air-fuel ratio, air flow and fuel flow in addition to engine, exhaust and catalyst temperatures. The chassis dynamometer facility incorporated an ‘industry standard’ measurement system comprising MEXA7400 gas analyzer and CVS bag sampling which was the ‘benchmark’ for the evaluation of FTIR legislated gas-phase emissions (CO, NOx, THC and CO2) measurements. Initial steady state measurements demonstrated strong correlations for CO, NOx and THC (R2 of 0.99, 0.97 0.99, respectively) and a good correlation for CO2 (R2 = 0.92). Subsequent transient and total mass emissions measurements from replicate samplings of four different driving cycles (two standard cycles, FTP75 and NEDC, and two novel cycles based on real-world data collected in Leeds) also show good response of FTIR and satisfied agreement between the FTIR and CVS bag sampling measurements. In general, the trial results demonstrate that the on-board FTIR emission measurement system provides reliable in-journey emissions data.

1 April 2007 in Science of The Total Environment
Verified
Journal Article
Closed access
Karl RopkinsKarl Ropkins
Karl Ropkins
RQRobert Quinn
Robert Quinn
JBJoe Beebe
Joe Beebe
HLHu Li
Hu Li
BDBasil Daham
Basil Daham
GAGordon Andrews
Gordon Andrews