Abdelnasir Omran

Mr. Abdelnasir Omran

Aston University, Birmingham, B4 7ET, United Kingdom
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 December 2020 in Energies
Verified
Journal Article
Open access
PDF file
Abed AlaswadAbed Alaswad
Abed Alaswad
Abdelnasir OmranAbdelnasir Omran
Abdelnasir Omran
JSJose Ricardo Sodre
Jose Ricardo Sodre
TWTabbi Wilberforce
Tabbi Wilberforce
GPGianmichelle Pignatelli
Gianmichelle Pignatelli
AOAbdul Ghani Olabi
Abdul Ghani Olabi
This review critically evaluates the latest trends in fuel cell development for portable and stationary fuel cell applications and their integration into the automotive industry. Fast start-up, high efficiency, no toxic emissions into the atmosphere and good modularity are the key advantages of fuel cell applications. Despite the merits associated with fuel cells, the high cost of the technology remains a key factor impeding its widespread commercialization. Therefore, this review presents detailed information into the best operating conditions that yield maximum fuel cell performance. The paper recommends future research geared towards robust fuel cell geometry designs, as this determines the cell losses, and material characterization of the various cell components. When this is done properly, it will support a total reduction in the cost of the cell which in effect will reduce the total cost of the system. Despite the strides made by the fuel cell research community, there is a need for public sensitization as some people have reservations regarding the safety of the technology. This hurdle can be overcome if there is a well-documented risk assessment, which also needs to be considered in future research activities.

1 May 2016 in Fuel
Verified
Journal Article
Open access
AHAbul Kalam Hossain
Abul Kalam Hossain
CSC. Serrano
C. Serrano
JBJ.B. Brammer
J.B. Brammer
Abdelnasir OmranAbdelnasir Omran
Abdelnasir Omran
FAF. Ahmed
F. Ahmed
PDPhilip Davies
Philip Davies
Digestate from the anaerobic digestion conversion process is widely used as a farm land fertiliser. This study proposes an alternative use as a source of energy. Dried digestate was pyrolysed and the resulting oil was blended with waste cooking oil and butanol (10, 20 and 30 vol.%). The physical and chemical properties of the pyrolysis oil blends were measured and compared with pure fossil diesel and waste\ud cooking oil. The blends were tested in a multi-cylinder indirect injection compression ignition engine. Engine combustion, exhaust gas emissions and performance parameters were measured and compared with pure fossil diesel operation. The ASTM copper corrosion values for 20% and 30% pyrolysis blends were 2c, compared to 1b for fossil diesel. The kinematic viscosities of the blends at 40 C were 5–7 times\ud higher than that of fossil diesel. Digested pyrolysis oil blends produced lower in-cylinder peak pressures than fossil diesel and waste cooking oil operation. The maximum heat release rates of the blends were approximately 8% higher than with fossil diesel. The ignition delay periods of the blends were higher; pyrolysis oil blends started to combust late and once combustion started burnt quicker than fossil diesel. The total burning duration of the 20% and 30% blends were decreased by 12% and 3% compared to fossil diesel. At full engine load, the brake thermal efficiencies of the blends were decreased by about 3–7% when compared to fossil diesel. The pyrolysis blends gave lower smoke levels; at full engine load, smoke level of the 20% blend was 44% lower than fossil diesel. In comparison to fossil diesel and at full load, the\ud brake specific fuel consumption (wt.) of the 30% and 20% blends were approximately 32% and 15% higher. At full engine load, the CO emission of the 20% and 30% blends were decreased by 39% and 66% with respect to the fossil diesel. Blends CO2 emissions were similar to that of fossil diesel; at full engine load, 30% blend produced approximately 5% higher CO2 emission than fossil diesel. The study concludes that on the basis of short term engine experiment up to 30% blend of pyrolysis oil from digestate of arable crops can be used in a compression ignition engine

1 February 2020 in Renewable Energy
Verified
Journal Article
Closed access
AHAbul Kalam Hossain
Abul Kalam Hossain
PRP. Refahtalab
P. Refahtalab
Abdelnasir OmranAbdelnasir Omran
Abdelnasir Omran
DSD.I. Smith
D.I. Smith
PDP.A. Davies
P.A. Davies

1 August 2022 in Energies
Verified
Journal Article
Open access
PDF file
TWTabbi Wilberforce
Tabbi Wilberforce
MBMohammad Biswas
Mohammad Biswas
Abdelnasir OmranAbdelnasir Omran
Abdelnasir Omran
A proton exchange membrane fuel cell (PEMFC) is a more environmentally friendly alternative to deliver electric power in various applications, including in the transportation industry. As PEMFC performance characteristics are inherently nonlinear and involved, the prediction of the performance in a given application for different operating conditions is important in order to optimize the efficiency of the system. Thus, modelling using artificial neural networks (ANNs) to predict its performance can significantly improve the capabilities of handling the multi-variable nonlinear performance of the PEMFC. However, further investigation is needed to develop a dynamic model using ANNs to predict the transient behavior of a PEMFC. This paper predicts the dynamic electrical and thermal performance of a PEMFC stack under various operating conditions. The input variables of the PEMFC stack for the analysis consist of the cathode inlet temperature, anode inlet pressure, anode and cathode inlet flow rates, and stack current. The performances of the ANN models using three different learning algorithms are determined based on the stack voltage and temperature, which have been shown to be consistently predicted by most of these models. Almost all models with varying hidden neurons have coefficients of determination of 0.9 or higher and mean squared errors of less than 5. Thus, the results show promise for dynamic modelling approaches using ANNs for the development of optimal operation of a PEMFC in various system applications.