In reconfigurable intelligent surface (RIS)-assisted symbiotic radio (SR), the RIS acts as a secondary transmitter by modulating its information bits over the incident primary signal and simultaneously assists the primary transmission, then a cooperative receiver is used to jointly decode the primary and secondary signals. Most existing works of SR focus on using RIS to enhance the reflecting link while ignoring the ambiguity problem for the joint detection caused by the multiplication relationship of the primary and secondary signals. Particularly, in case of a blocked direct link, joint detection will suffer from severe performance loss due to the ambiguity, when using the conventional on-off keying and binary phase shift keying modulation schemes for RIS. To address this issue, we propose a novel modulation scheme for RIS-assisted SR that divides the phase-shift matrix into two components: the symbol-invariant and symbol-varying components, which are used to assist the primary transmission and carry the secondary signal, respectively. To design these two components, we focus on the detection of the composite signal formed by the primary and secondary signals, through which a problem of minimizing the bit error rate (BER) of the composite signal is formulated to improve both the BER performance of the primary and secondary ones. By solving the problem, we derive the closed-form solution of the optimal symbol-invariant and symbol-varying components, which is related to the channel strength ratio of the direct link to the reflecting link. Moreover, theoretical BER performance is analyzed. Finally, simulation results show the superiority of the proposed modulation scheme over its conventional counterpart.

Due to the characteristics of global coverage, on-demand access, and large capacity, the low earth orbit (LEO) satellite communication (SatCom) has become one promising technology to support the Internet-of-Things (IoT). However, due to the scarcity of satellite spectrum and the high cost of designing satellites, it is difficult to launch a dedicated satellite for IoT communications. To facilitate IoT communications over LEO SatCom, in this paper, we propose the cognitive LEO satellite system, where the IoT users act as the secondary user to access the legacy LEO satellites and cognitively use the spectrum of the legacy LEO users. Due to the flexibility of code division multiple access (CDMA) in multiple access and the wide use of CDMA in LEO SatCom, we apply CDMA to support cognitive satellite IoT communications. For the cognitive LEO satellite system, we are interested in the achievable rate analysis and resource allocation. Specifically, considering the randomness of spreading codes, we use the random matrix theory to analyze the asymptotic signal-to-interference-plus-noise ratios (SINRs) and accordingly obtain the achievable rates for both legacy and IoT systems. The power of the legacy and IoT transmissions at the receiver are jointly allocated to maximize the sum rate of the IoT transmission subject to the legacy satellite system performance requirement and the maximum received power constraints. We prove that the sum rate of the IoT users is quasi-concave over the satellite terminal receive power, based on which the optimal receive powers for these two systems are derived. Finally, the resource allocation scheme proposed in this paper has been verified by extensive simulations.

In this letter, we study the channel estimation problem for the reconfigurable intelligent surface (RIS)-aided multi-input single-output (MISO) system. By exploiting the channel sparsity, compressive sensing (CS) based sparse channel estimators can be applied to the system to reduce the training overhead. However, these existing sparse channel estimators adopt predefined dictionaries when formulating the sparse matrix recovery problem, which will cause grid mismatch issues and estimation performance degradation. Hence, in this letter, we formulate the channel estimation problem as a joint dictionary parameter learning and sparse signal recovery problem, in which the dictionary parameter can be optimized to adapt to the channel measurements, thereby improving the robustness of sparse channel representation and estimation performance. Then, we propose an iterative re-weighted algorithm to solve this non-convex problem efficiently. Simulation results show that the proposed algorithm outperforms other benchmark schemes significantly.

D2D communication is a promising technology for enhancing spectral efficiency (SE) in cellular networks, and full-duplex (FD) has the potential to double SE. Due to D2D’s short-distance communication and low transmittance power, it is natural to integrate FD into D2D, creating FD-D2D to underlay a cellular network to further improve SE. However, the residual self-interference (RSI) resulting from FD-D2D and interference arising from spectrum sharing between D2D users (DUs) and cellular users (CUs) can restrict D2D link performance. Therefore, we propose an FD-D2D underlying cellular system in which DUs jointly share uplink and downlink spectral resources with CUs. Moreover, we present two algorithms to enhance the performance experience of DUs while improving the system’s SE. For the first algorithm, we tackle an optimization problem aimed at maximizing the sum rate of FD-DUs in the system while adhering to transmittance power constraints. This problem is formulated as a mixed-integer nonlinear programming problem (MINLP), known for its mathematical complexity and NP-hard nature. In order to address this MINLP, our first algorithm decomposes it into two subproblems: power control and spectral resource allocation. The power control aspect is treated as a nonlinear problem, which we solve through one-dimensional searching. Meanwhile, spectral resource allocation is achieved using the Kuhn–Munkres algorithm, determining the pairing of CUs and DUs sharing the same spectrum. As for the second algorithm, our objective is to enhance the individual performance of FD-DUs by maximizing the minimum rate among them, ensuring more uniform rate performance across all FD-DUs. In order to solve this optimization problem, we propose a novel spectral resource allocation algorithm based on bisection searching and the Kuhn–Munkres algorithm, whereas the power control aspect remains the same as in the first algorithm. The numerical results demonstrate that our proposed algorithm effectively enhances the performance of DUs in an FD-D2D underlying cellular network when compared to the sum rate maximization design.

This paper proposes a system of 6G Internet of Things (IoT) based on downlink non-orthogonal multiple access (NOMA) technology, where the base station (BS) allows signals of the same frequency to serve users at different distances. In particular, we study a cooperative MIMO-NOMA system based on downlink simultaneous wireless information and power transfer (SWIPT) assistance. To improve the overall performance, we employ machine learning to optimize user-pairing and radio resource allocation. At the end of the paper, the simulation results are obtained, which fully prove that the MIMO-NOMA system constructed in this paper is correct in theory and can be realized in practice.