The microgrid includes a distribution system with low voltage, controllable load, and distributed energy resources (DER). The DERs have been increased in the recent power network to address global environmental concerns, which creates challenges in faults, synchronization, inertia control, etc. As the technologies are getting advanced day by day, the past technology becomes obsolete. The internet of things (IoT) and artificial intelligence (AI) are the most discussed topics to obtain solutions for the challenges. One of the proposed solutions is adaptive overcurrent protection, as it can be used for any grid. In this paper, an algorithm is developed for the adaptive overcurrent relay protection to overcome the challenges of the microgrid with distributed energy resources. Then, the solutions obtained from the adaptive overcurrent protection algorithm network simulation are compared to the traditional overcurrent protection algorithm using the four key points such as selectivity, reliability, sensitivity, and speed to have a good performance in the power network. All the simulation studies are done in the electrical transient analyzer program (ETAP) software environment. Simulation results validate the performance of the proposed algorithm for adaptive protection using the IEEE-9 bus system with a microgrid.
Conventional protection system has relays with fixed setting parameters. It becomes difficult to fulfill the protection requirements in variable operation conditions in general power systems. One of the solution to this problem is the adaptive protection which can vary its parameter settings or the operating characteristics in response to changes in the power system. Using such adaptive protection helps to improve the defects of traditional protection system which can make the protection system better: more reliable, sensitive and rapid. These characteristics and functions can be achieved by properly designing the electrical system and the protection scheme. At the same time ensure that the selected protection can detect and isolate all faulted portions of the electrical system. To guarantee the safety of the task of the power system, the protection equipment ought to be upgraded in like manner. Hence, the energetic structure of power system and their different working conditions need the advancement of adaptive protection techniques. This paper provides the concepts for the general and modern power system protections and highlights the adaptive protection scheme. The overall structure of the adaptive protection is described. The recommendations including software and functions for the future power systems are discussed.
Modern power system is more flexible and complex than the conventional power system. From a reliability point of view it is important to identify and isolate the fault as fast as possible from the neighbouring zones. This paper proposes protection solutions for smart grid. In particular, the main focus of this paper is on three different protections namely overcurrent protection, transformer protection, and directional overcurrent protection. The proposed protection solutions are validated through IEEE- 9 bus and 14 bus electrical power systems. ETAP software has been used to verify the system operation.
The current electrical power distribution networks are normally connected in a radial structure. It is expected to have a high penetration of distributed generators (DG) in the future electrical power distribution systems. The impact of DG on the protection system is one of the major challenges for the operation of modern power systems. Typically, the fault current level of a power system depends on the sources of the grid. However, when the distribution system is connected to DG, the fault current increases. The fault current level changes due to the penetration level of DG. As a result, it changes the setting of protection coordination and causes malfunctioning. Thus, one of the proposed solutions for protection is the use of adaptive overcurrent protection. This paper presents the impact of the distributed generators on power system protection and the use of adaptive overcurrent protection to overcome these challenges. The advantage of this protection is that it adapts real-time changes automatically. The proposed protection solution was applied to the IEEE-9 bus electrical power system where several DGs are connected. Also, an extracting part of a complex microgrid is used as another case study to verify the proposed solution. These studies were carried out on ETAP software and shows the capability of adopting the protection system when there is a high presence of DGs.