In fluid mechanics, drag related problems aim to reduce fuel consumption. This paper is intended to provide guidance for drag reduction applications on cars. The review covers papers from the beginning of 2000 to April 2020 related to drag reduction research for ground vehicles. Research papers were collected from the library of Science Direct, Web of Science, and Multidisciplinary Digital Publishing Institute (MDPI). Achieved drag reductions of each research paper was collected and evaluated. The assessed research papers attained their results by wind tunnel measurements or calculating validated numerical models. The study mainly focuses on hatchback and notchback shaped ground vehicle drag reduction methods, such as active and passive systems. Quantitative analysis was made for the drag reduction methods where relative and absolute drag changes were used for evaluations.
As a result of COVID-19, many office buildings around the world have downsized their employees, but the comfort parameters in the building had to be kept. The facilities operation rearranged the workstations to keep physical distance and placed plexiglass sheets on the desks for physical protection. A series of measurements have been carried out with workstation set-ups to examine the fresh air rate in the occupied zone. The effect of plexiglass sheets placed on the desks was also examined to see how it changes the airflow pattern in the occupied zone. As the sheets act as a barrier, the primary air does not reach the occupied zone, therefore, the fresh air rate is less. To modify the properties of the ceiling diffusers a new air-ventilation service element was developed. This attachment allows modifying the properties of the ceiling diffusers. Simulations were made at the relevant zones to validate the measurements. Based on design software, the fresh air ratio for a standard ceiling swirl diffuser is 2.46 v% (volume percentage). A numerical model was used to show the fresh air ratio with the system elements for the two different table arrangements, which were 18.3 v% and 21.4 v%, respectively.
1 January 2014 in Environmental Engineering and Management Journal
Energy saving is one of the most important research directions in the building sector. Personalized ventilation systems are energy conscious solutions providing fresh air for the occupants. As a side effect, cooling energy can be saved due to higher convective heat removal. Using the data gathered from previous experiments performed with the developed personalized ventilation system, a ±1.408 °C accurate simulation model was created in ANSYS 19.2 Academic version in order to determine the temperature distribution on the face. In this paper, the method and the first results are presented. It was clearly demonstrated by measurements and simulations that the personalized ventilation equipment used has a considerable effect on the skin temperature of the face. The developed model can be used to analyze the skin temperature on the faces of people using the novel, personalized ventilation equipment. This way the time spent on examination can be reduced considerably.