Aims: Indoor air quality (IAQ) has attracted increased attention with the emergence of COVID-19. Ventilation is perhaps the area in which the most changes have been proposed in response to the emergency caused by this virus. However, other strategies are possible, such as source control and the extraction of pollutants. The latter incorporates clean technologies, an emergent area with respect to IAQ. Method: Various air treatment technologies can be used to control contaminants, which are reviewed and discussed in this work, including physicochemical technologies (e.g., filtration, adsorption, UV-photocatalytic oxidation, ultraviolet disinfection and ionization) and biological technologies (e.g., plant purification methods and microalgae-based methods). Results and interpretation: This work reviews currently available solutions and technologies for “cleaning” indoor air, with a focus on their advantages and disadvantages. One of the most common problems in this area is the emission of pollutants that are sometimes more dangerous to human health than those that the technologies were developed to remove. Another aspect to consider is the limitation of each technology in relation to the type of pollutants that need to be removed. Each of the investigated technologies works well for a family of pollutants with similar characteristics, but it is not applicable to all pollutant types. Thus, the optimal solution may involve the use of a combination of technologies to extend the scope of application, in addition to the development of new materials, for example, through the use of nanotechnology.
Polycyclic aromatic compounds (PACs) in particulate matter contribute considerably to the health risk of air pollution. As such, we have optimized a method to determine the levels of polycyclic aromatic hydrocarbons, especially nitrated and oxygenated polycyclic aromatic hydrocarbons, in samples of PM10 particulate matter using microwave-assisted extraction (MAE) and gas chromatography coupled to a triple quadrupole mass spectrometer (GC-MS/MS). The proposed method was applied to the analysis of real samples collected in the urban area of Ciudad Real (Spain) during one year. The median total concentrations of eighteen PAHs (∑PAHs) and seven OPAHs (∑OPAHs) were 0.54 and 0.23 ng m-3, respectively, with the corresponding value for NPAH (∑NPAHs) being 0.03 ng m-3 (only detected in 40% of samples). A clear seasonal trend was observed, with higher levels in the cold season and lower in the warm season for ∑PAHs. The same effect was observed for ∑OPAHs, which exhibited a median concentration of 0.72 ng m-3 in the cold season and 0.10 ng m-3 in the warm season, and for ∑NPAH, which exhibited a median of 0.04 ng m-3 in the cold season but were not detected in the warm season. Molecular diagnostic ratios and PCA (principal component analysis) showed a predominantly traffic origin for PACs. The sources of PAHs also depend on meteorological conditions and/or atmospheric reactions, as confirmed by means of statistical analysis. The ∑OPAH/∑PAH and ∑NPAH/∑PAH ratios were higher in the cold season than the warm season, thus suggesting that PAH derivatives originated from primary combustion emission sources together with their parent PAHs. The concentration range found for benzo(a)pyrene was 0.006-0.542 ng m-3, which is below the threshold value of 1 ng m-3 established in European legislation as the annual average value. The lifetime lung risk from inhalation of PM10-bound PACs was estimated to be six cancer cases per million people using the World Health Organization method.
1 August 2015 in International Journal of Hygiene and Environmental Health
Effective evidence-based actions to reduce indoor air pollution must be derived from data obtained using accurate means for assessment of the critical air pollutants and for the identification of their sources. This is of paramount importance to provide robust evidence for establishing effective policies or preventive measures. Nevertheless, designing a reliable sampling plan for assessing concentration of inorganic pollutant in the indoor air requires expertise in conducting rigorous sampling campaigns and proper knowledge on the existing standards and methodologies for assessing concentration of the target substances. Therefore, this review focuses on the relevant information and recommendations that should be considered when designing a sampling plan to collect complementary data on the indoor environment under study, to properly define the criteria for establishing the details for the work and to ensure the quality of the assessments. In particular, comprehensive information on the most commonly used methodologies for the determination of a list of critical inorganic pollutants for indoor air quality monitoring has been compiled. Thus, inorganic gaseous pollutants such as CO2, CO, O3, NO2, NO, NH3, SO2, H2O2, H2S, HNO3 and HNCO are included in the present review.