Multimode fibers are attractive for high-power lasers if transverse modes are efficiently controlled. Here, a dielectric thin-film mirror (R~20%) is micro-fabricated on the central area of the end face of a 1 km multimode 100/140 µm graded-index fiber and tested as the output mirror of a Raman laser with highly multimode (M2~34) 940 nm diode pumping. In the cavity with highly reflective input FBG, Raman lasing of the Stokes wave at 976 nm starts at the threshold pump power of ~80 W. Mode-selective properties of mirrors with various diameters were tested experimentally and compared with calculations in COMSOL, with the optimum diameter found to be around 12 µm. The measured Raman laser output beam at 976 nm has a quality factor of M2~2 near the threshold, which confirms a rather good selection of the fundamental transverse mode. The power scaling capabilities, together with a more detailed characterization of the output beam’s spatial profile, spectrum, and their stability, are performed. An approximately 35 W output power with an approximately 60% slope efficiency and a narrow spectrum has been demonstrated at the expense of a slight worsening of beam quality to M2~3 without any sign of mirror degradation at the achieved intensity of >30 MW/cm2. Further power scaling of such lasers as well as the application of the proposed technique in high-power fiber lasers are discussed.
Using numerical simulation in COMSOL Multiphysics software we demonstrate for the first time the possibility of selecting a fundamental whispering gallery
To investigate the possibility of selecting a fundamental mode with high Q-factor in a microsphere using COMSOL software, a numerical simulation based on ohmic losses in two thin metal claddings with a thickness of 5 nm was performed. These claddings were deposited on a microsphere with a radius of 80 μm, one of which was located inside and the other outside, forming a gap between them. The location of the claddings and gap size were selected to optimize the ratio of the Q-factor for the main mode TEl,l,1 compared to the maximum Q-factors of two groups of modes: "radial" TEn,n,q, q = 2, 3, 4, 5 and "azimuthal" TEl,m,1, |m| = l – 1, l – 2, l – 3, l – 4. Using a continuous metal layer at an optimal position along the radius of the sphere opt rme = 72,4 μm and a surface metal layer with an optimal gap width Gopt = 27,5 μm, the Qfactor of the radial mode group was reduced by at least a factor of 260 and that of the azimuthal mode group by a factor of at least 19 near the wavelength of λ = 1550 nm. It has also been shown that the selection of the fundamental mode is possible over a wide spectral range (polar indices l).
This study addresses the problem of whispering gallery mode (WGM) selection in spherical microresonators by means of their femtosecond micro-processing. The proposed method involves fabrication on the microsphere surface of defects playing the role of scattering elements for higher-order modes with low azimuthal mode indices. These two T-shaped trenches are created using femtosecond laser ablation, with a depth of 2 microns, gap of 30 microns between them, and each of length of 20 microns along the equatorial direction. A tapered fiber with a sub-micron waist diameter serves as the excitation element for WGMs. This method allows for spectral purification of the WGMs, reducing the number of resonances by 180 times, with a quality factor of for the non-inverted spectrum in the form of resonance dips. Additionally, an inverted spectrum with narrow resonance peaks of about 35%, low background level and single mode regime with 3 dB side peak suppression has been simultaneously achieved in the taper transmission, for the first time to our knowledge. The latter was obtained by exciting the microsphere at the taper waist. These results hold promise for the development of narrowband filters, laser mode selectors, and optical sensors based on microresonators.