Jaroslav Otta

Dr. Jaroslav Otta

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 November 2024 in ACS Omega
Verified
Journal Article
Open access
DMDominik Maršík
Dominik Maršík
MDMatěj Danda
Matěj Danda
JOJaroslav Otta
Jaroslav Otta
PTPetter P. Thoresen
Petter P. Thoresen
OMOlga Mat́átková
Olga Mat́átková
JMJan Masák
Jan Masák
Silver nanoparticles (AgNPs) are excellent antimicrobial agents and promising candidates for preventing or treating bacterial infections caused by antibiotic resistant strains. However, their increasing use in commercial products raises concerns about their environmental impact. In addition, traditional physicochemical approaches often involve harmful agents and excessive energy consumption, resulting in AgNPs with short-term colloidal stability and silver ion leaching. To address these issues, we designed stable hybrid lignin-silver nanoparticles (AgLigNPs) intended to effectively hit bacterial envelopes as a main antimicrobial target. The lignin nanoparticles (LigNPs), serving as a reducing and stabilizing agent for AgNPs, have a median size of 256 nm and a circularity of 0.985. These LigNPs were prepared using the dialysis solvent exchange method, producing spherical particles stable under alkaline conditions and featuring reducing groups oriented toward a wrinkled surface, facilitating AgNPs synthesis and attachment. Maximum accumulation of silver on the LigNP surface was observed at a mass reaction ratio mAg:mLig of 0.25, at pH 11. The AgLigNPs completely inhibited suspension growth and reduced biofilm development by 50% in three tested strains of Pseudomonas aeruginosa at a concentration of 80/9.5 (lignin/silver) mg L-1. Compared to unattached AgNPs, AgLigNPs required two to eight times lower silver concentrations to achieve complete inhibition. Additionally, our silver-containing nanosystems were effective against bacteria at safe concentrations in HEK-293 and HaCaT tissue cultures. Stability experiments revealed that the nanosystems tend to aggregate in media used for bacterial cell cultures but remain stable in media used for tissue cultures. In all tested media, the nanoparticles retained their integrity, and the presence of lignin facilitated the prevention of silver ions from leaching. Overall, our data demonstrate the suitability of AgLigNPs for further valorization in the biomedical sector.

13 October 2023 in Applied Surface Science
Verified
Journal Article
Closed access
Martin HruškaMartin Hruška
Martin Hruška
JKJan Kejzlar
Jan Kejzlar
JOJaroslav Otta
Jaroslav Otta
PFPřemysl Fitl
Přemysl Fitl
MNMichal Novotný
Michal Novotný
MVMartin Vrňata
Martin Vrňata

2 September 2021 in Chemosensors
Verified
Journal Article
Open access
PDF file
Alfio TorrisiAlfio Torrisi
Alfio Torrisi
JVJiri Vacik
Jiri Vacik
GCGiovanni Ceccio
Giovanni Ceccio
ACAntonino Cannavò
Antonino Cannavò
VLVasily Lavrentiev
Vasily Lavrentiev
MVMartin Vrňata
Martin Vrňata
Chemiresistors based on thin films of the Li-doped CuO–TiO2 heterojunctions were synthesized by a 2-step method: (i) repeated ion beam sputtering of the building elements (on the Si substrates and multisensor platforms); and (ii) thermal annealing in flowing air. The structure and composition of the films were analyzed by several methods: Rutherford Backscattering (RBS), Neutron Depth Profiling (NDP), Secondary Ion Mass Spectrometry (SIMS), and Atomic Force Microscopy (AFM), and their sensitivity to gaseous analytes was evaluated using a specific lab-made device operating in a continuous gas flow mode. The obtained results showed that the Li doping significantly increased the sensitivity of the sensors to oxidizing gases, such as NO2, O3, and Cl2, but not to reducing H2. The sensing response of the CuO–TiO2–Li chemiresistors improved with increasing Li content. For the best sensors with about 15% Li atoms, the detection limits were as follows: NO2 → 0.5 ppm, O3 → 10 ppb, and Cl2 → 0.1 ppm. The Li-doped sensors showed excellent sensing performance at a lower operating temperature (200 °C); however, even though their response time was only a few minutes, their recovery was slow (up to a few hours) and incomplete.

9 December 2025 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
HŠHelena Šimůnková
Helena Šimůnková
Martin HruškaMartin Hruška
Martin Hruška
JOJaroslav Otta
Jaroslav Otta
JMJan Mišek
Jan Mišek
PSPetr Smísitel
Petr Smísitel
JHJaromir Hubalek
Jaromir Hubalek

31 March 2025 in Materials Advances
Verified
Journal Article
Open access
PDF file
JKJan Kejzlar
Jan Kejzlar
Joris More-ChevalierJoris More-Chevalier
Joris More-Chevalier
Martin HruškaMartin Hruška
Martin Hruška
JOJaroslav Otta
Jaroslav Otta
PFPřEmysl Fitl
PřEmysl Fitl
JLJán Lančok
Ján Lančok
The gas sensing mechanism of the sensor equipped with a black gold active layer. Surface adsorption of the gaseous analyte causes a shift in the sensor's electrical resistance.

21 May 2018 in Soft Matter
Verified
Journal Article
Closed access
PDF file
RERoman Elashnikov
Roman Elashnikov
ATA. Trelin
A. Trelin
JOJaroslav Otta
Jaroslav Otta
PFP. Fitl
P. Fitl
DMD. Mares
D. Mares
OLOleksiy Lyutakov
Oleksiy Lyutakov
A simple way to create periodical structures on transparent polymer films by plasmon-assisted lithography.