Jiayue Wan

Dr. Jiayue Wan

Beijing Institute of Technology, Beijing, China
orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 January 2017 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Jiayue WanJiayue Wan
Jiayue Wan
ZCZhiming Chen
Zhiming Chen
QAQiang An
Qiang An
XWXinghua Wang
Xinghua Wang
In this letter, a truly balanced CMOS Q-band frequency doubler with an ultra-compact differential hybrid quadrature coupler is demonstrated using 90-nm CMOS technology. The doubler incorporates two Gilbert-cells fed by I/Q signals to compensate the time delay from transconductance stage and avoid output DC offset, providing truly balanced differential outputs. The doubler achieves a 3-dB bandwidth from 40 to 49 GHz with a minimum conversion loss of 1.6 dB at 44 GHz, while the output amplitude imbalance is measured to be less than 0.7dB. The measured I/Q mismatch of the quadrature coupler is less than 1° within 10 GHz bandwidth. The doubler chip consumes 9.6 mA from a 1.2-V supply, and the chip dimension is 0.7 × 0.9 mm 2 .

7 June 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
Jiayue WanJiayue Wan
Jiayue Wan
ZFZesong Fei
Zesong Fei
ZLZicheng Liu
Zicheng Liu
QQQuanwen Qi
Quanwen Qi
FHFang Han
Fang Han
ZCZhiming Chen
Zhiming Chen
This paper proposes a dual-core quad-mode millimeter-wave (mm-wave) voltage-controlled oscillator (VCO) using a compact multi-mode LC network with a modeindependent switched transformer technique. On top of the dualmode main LC tank, the mode-independent switched transformer technique introduces two additional oscillation modes, further extending the frequency tuning range with a small chip area overhead, while the mode-independent feature reduces the cost of switch off-capacitance compared with the conventional switched transformers. Implemented in 65nm CMOS process, the proposed VCO achieves a measured octave frequency tuning range from 20.65 to 40.55 GHz. The measured best phase noise is -131.04 dBc/Hz at 10 MHz offset from 20.65 GHz. The measured best figure-of-merit (FoM) is 187.25 dBc/Hz at 10 MHz offset from 26.66 GHz, corresponding to a figure-of-merit of tuning range and area (FoMTA) of 216.72 dBc/Hz thanks to the proposed compact multi-mode LC network and the mode-independent switched transformer technique. The VCO consumes 9.75-to-18.85 mW from a 0.65 V supply voltage. The core area is 0.048 mm2.

12 May 2022 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Jiayue WanJiayue Wan
Jiayue Wan
XLXiao Li
Xiao Li
ZFZesong Fei
Zesong Fei
FHFang Han
Fang Han
Xiaoran LiXiaoran Li
Xiaoran Li
ZCZhiming Chen
Zhiming Chen
In this letter, low-phase-nose multicore class-F voltage-controlled oscillators (VCOs) using coupled-lined-based synchronization topology are proposed. Compared to traditional resistance-coupled multicore VCOs, the proposed coupled-line-based topology improves the $Q$ of the small inductors in the millimeter-wave frequency range. Mode ambiguity is eliminated for a robust oscillation startup. Quad-core and oct-core VCO prototypes are designed and implemented in 65-nm CMOS process, which exhibit a measured frequency tuning range of 20.5% centered at 31.32 GHz. The quad-core VCO has a measured phase noise (PN) of −134.33 dBc/Hz and a corresponding FoM of 191.32 dBc/Hz at 10-MHz offset from 28.28 GHz. The oct-core VCO has a measured PN of −137.23 dBc/Hz and a corresponding FoM of 191.08 dBc/Hz at 10-MHz offset from 28.16 GHz.

9 June 2022 in Electronics
Verified
Journal Article
Open access
PDF file
Jiayue WanJiayue Wan
Jiayue Wan
XLXiao Li
Xiao Li
FHFang Han
Fang Han
QQQuanwen Qi
Quanwen Qi
XLXuzhi Liu
Xuzhi Liu
ZCZhiming Chen
Zhiming Chen
This paper presents a differential 19.6–39.4 GHz broadband low-noise amplifier (LNA) in 65-nm CMOS technology. The LNA consists of two cascode stage and one common-source stage. To achieve a wide bandwidth and low average noise figure, inter-stage peak-gain distribution technique and transformer-based triple-coupled technique are developed. Besides, a new compact T-coil-based network is proposed to neutralize the parasitic capacitors and enlarge the gain. The measure results show that the 3-dB bandwidth is from 19.6 to 39.4 GHz, the maximum gain is 23.5 dB, and the noise figure (NF) is from 3.7 to 5.8 dB. The dc power comsumption is 46 mW with 1V supply voltage. The input P1dB is −17 dBm at 30 GHz.

23 December 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
JGJian Gao
Jian Gao
Xinghua WangXinghua Wang
Xinghua Wang
FHFang Han
Fang Han
Jiayue WanJiayue Wan
Jiayue Wan
WGWei Gu
Wei Gu
A circulator, which is a non-reciprocal device, is widely used in full-duplex systems, future communication and sensing networks, and quantum computing, and it is difficult to implement a passive topology on a chip. Based on switch-based spatio-temporal conductivity modulation, in this study, we design and implement a non-magnetic on-chip passive circulator operating at the Ku band in a 90-nm bulk CMOS technology using a 25% duty-cycle I/Q clock signal. With the virtue of the four-phase non-overlapping clock signal, the proposed circulator achieves a 3.9 dB transmitter (TX)-to-antenna (ANT) and a 4.0 dB ANT-to-receiver (RX) insertion loss with a 1-dB bandwidth of 2.7 GHz (21.4%). The TX-to-RX isolation is better than 17.2 dB, and the TX-to-ANT IIP3 and ANT-to-RX IIP3 are 19.7 dBm and 20.0 dBm, respectively, while occupying a die area of 1.55 mm × 1.15 mm. Although low-cost bulk CMOS technology is used, competitive isolation, linearity performance, and isolation bandwidth are achieved in the proposed design.