Anisotropic gold nanodiscs (AuNDs) possess unique properties, such as large flat surfaces and dipolar plasmon modes, which are ideal constituents for the fabrication of plasmonic assemblies for novel and emergent functions. In this report, we present the thermo-responsive assembly and thermo-dynamic behavior of AuNDs functionalized with methyl-hexa(ethylene glycol) undecane-thiol as a thermo-responsive ligand. Upon heating, the temperature stimulus caused a blue shift of the plasmon peak to form a face-to-face assembly of AuNDs due to the strong hydrophobic and van der Waals interactions between their large flat surfaces. Importantly, AuNDs allowed for the incorporation of the carboxylic acid-terminated ligand while maintaining their thermo-responsive assembly ability. With regard to their reversible assembly/disassembly behavior in the thermal cycling process, significant rate-independent hysteresis, which is related to their thermo-dynamics, was observed and was shown to be dependent on the carboxylic acid content of the surface ligands. As AuNDs have not only unique plasmonic properties but also high potential for attachment due to the fact of their flat surfaces, this study paves the way for the exploitation of AuNDs in the development of novel functional materials with a wide range of applications.
14 August 2025 in Journal of Materials Chemistry A
The need for thermal energy storage as a middle-long duration energy storage technology has increased in tandem with the widespread adoption of variable renewable energy sources. Latent heat storage using metallic phase change materials (PCMs) presents a promising solution by combining high thermal conductivity with high heat storage density. Recent advances in microencapsulated PCMs (MEPCMs) have addressed corrosion and leakage issues commonly associated with metallic PCMs. This study develops an MEPCM composite, with suitable structure, performance, and strength for adapting GWh-scale thermal energy storage systems, using an Al–Cu–Si-based MEPCM as the primary component. The MEPCM composite is fabricated by microencapsulating Al–Cu–Si eutectic alloy powder, which has a eutectic temperature of 520 °C, with an Al oxide shell formed via chemical conversion and heat-oxidation treatments, followed by mixing with an alumina sintering aid, forming, and sintering. The composite exhibits a heat storage density of approximately 1.0 GJ m–3 under a temperature difference (ΔT) of 200 °C, which is 2–3 times higher than that of conventional sensible heat storage materials. It retains both its heat storage performance and structural integrity after 1000 thermal cycles. The thermal conductivity ranges from 4.1 to 6.6 W m–1 K–1 between 300 and 600 °C. This study is the first to evaluate the compressive strength of composite PCMs in the liquid state, where the composite retains a compressive strength of 32 MPa at 600 °C—a value comparable to that of ordinary concrete. In the solid state, the composite exhibits 83 MPa at room temperature and 49 MPa at 500 °C. Thus, MEPCM composites are expected to possess substantial compressive strength for applications in medium-to-high-temperature heat storage and thermal management systems, even beyond the eutectic temperature of the PCM.
Heat storage heater can convert electricity into heat and store the high-temperature heat above 400 °C in the form of latent heat. This novel device is expected to be applied to Carnot batteries and power to heat technologies.