This paper presents the results of an experimental study on the behavior of the cold- formed steel shear wall panel (CFSSWP) with fibrocement panels as sheathing, when it is subjected in-plane shear deformations and flexural deformation under perpendicular monotonically increasing horizontal loads on the longest plane. A full-scale housing section was built with three walls and a ceiling using commonly used construction details in El Salvador. The strength and stiffness of the experimental specimen tested overcame significantly critical demand imposed by the technical design standards in this country. Additionally, a simplified finite element model was defined with the objective to analyze stresses in the components. The results of the numerical model were similar to the experimental model tested.
ResumenEste artículo presenta el análisis mediante técnicas numéricas y experimentales de componentes T-equivalente asimétricas, refiriéndose ésta al posicionamiento de los pernos respecto al alma del perfil. El objetivo principal de realizar este análisis es el de evaluar la influencia de dicha asimetría en la rigidez y sobre todo en la resistencia final, y compararlas a las de componentes simétricas. Se definen dos modelos numéricos para analizar el comportamiento: uno matricial de barras rígidas y otro con elementos finitos sólidos. Los resultados obtenidos con ambos modelos se comparan con ensayos experimentales, tanto para para una componente simétrica como una asimétrica, obteniéndose un error menor del 10 % para el cálculo de la rigidez e inferior al 20% para la resistencia final. Se comprueba que, como cabía esperar, la asimetría repercute en una redistribución de la carga en los pernos, produciéndose un fallo prematuro del conjunto con respecto a la configuración simétrica. Por tanto, puede deducirse que los análisis numéricos realizados son capaces de cuantificar dicha redistribución.AbstractThe analysis of asymmetric T-stub components by the position of bolts respect to the web, has been carried out using numerical and experimental approaches. The main objective of this analysis is to evaluate the influence of such asymmetry on the stiffness and strength. A matrix frame model with beam-column elements and rigid connections has been developed as well as with solid elements. Results obtained with these numerical models have been compared with those obtained from experimental tests carried out, for both symmetrical and asymmetrical components, obtaining errors below 10% for stiffness and lower than 20% for the final strength. It was found, as expected, that the asymmetry leads to a redistribution of the load on the bolts, causing premature failure of the assembly. Therefore the numerical analysis performed is capable of quantifying such redistribution
Thermoelastic Stress Analysis (TSA) has been used to obtain the stress field in bolted T-Stub joint models (as defined by Eurocode 3) subject to cyclic loading which were employed to validate a Finite Element (FE) model. It was concluded from the results of the experiments and modeling that the behavior of the T-Stub is more complex than claimed by Eurocode due to contact forces, bolt interaction and plastic behavior.