Faced with the raw material crisis in Zn resources, researchers are facing the challenge of developing technology for producing zinc coatings that are thinner than those that have been produced to date. This would make it possible to reduce Zn consumption in the hot-dip galvanisation process. The study included an experiment that involved dip galvanising steel samples in baths of different Ti concentrations; this process was carried out at 450 °C and 550 °C. The use of this additive made it possible to reduce the growth of the alloy layer in the obtained zinc coatings. Using an optical microscope, observations were made of the microstructures of the resulting coatings, which made it possible to determine the thickness of the alloy layer in the coating. Thanks to the use of scanning electron microscopy with EDS analysis, however, it was possible to plot the chemical composition of the studied coatings and accurately observe the morphology of the formed phases. An intermetallic Zn-Fe-Ti phase was observed in the coatings formed in a Ti-added bath, which can affect the growth inhibition of the alloy layer in the zinc coating.
Modeling the structure not only of whole metal products, but also of the protective coatings with which they are coated, brings a number of economic benefits through more resistant coatings and coatings that can be produced by simplifying manufacturing technology or reducing material consumption in the process. This paper presents the results of a study of dip metallization in zinc baths with Ti additions. Both steel and cast iron substrates were coated and similar results were obtained. The obtained coatings were subjected to SEM analysis with chemical composition studies, TEM characterization with selected area electron diffraction (SAED), and corrosion studies. Particle models of the elementary phases present in the zinc coating made with CaRine 3.0 software were presented and used for phase analysis. It emerged that coatings obtained in zinc baths with the addition of Ti are characterized by a more varied microstructure, the occurrence of phase separations to which Ti segregates, and higher corrosion resistance than classical zinc coatings. The higher corrosion resistance is prompted not only by the Ti content in the intermetallic phases, but also by the observed nanostructure favorably located in the alloy layer.
30 December 2025 in Archives of Foundry Engineering
The subject of the work is to prove that correct inoculation improves the properties of high chromium cast iron. The analysis was performed in terms of the effect of Fe-Nb-based and Fe-Ti-based inoculators on the starting alloy. Defects in castings such as porosity cracks and shrinkage cavities are a huge problem for companies producing chromium iron range. Reducing the occurrence of the aforementioned defects will result in more profitable and repeatable production. A stabilized and controlled production process provides guarantees of competitiveness in terms of price as well as timing in the market. It seems that the procedure of inoculation of HCCI cast iron, which has not yet been implemented on an industrial scale, turns out to be helpful in these problems. The inoculation used should have a significant effect on the fragmentation of the primary austenite structure as well as affect the alloy in the area of carbide eutectic crystallization. The thesis that can be formulated is that the inoculation will allow to improve the functional properties of castings free from defects such as hot cracking. Industrial tests were carried out at the “Swidnica” Foundry Ltd. which made it possible to show that it is possible to perform correct inoculation of high chromium cast iron under the conditions of the foundry's production line. In addition, it was shown that the inoculation of Fe-Nb better than Fe-Ti affects the functional properties of the inoculated alloy. It turned out that a small addition of Fe-Ti inoculant leads to the formation of TiC carbides. In contrast, the formation of NbC carbide was not demonstrated in the study with the use of Fe-Nb inoculant. In this case, the formation of an intermetallic phase was observed.