Modern public transport is increasingly turning to cleaner energy solutions such as compressed natural gas (CNG) or biomethane and hydrogen fuel cells. These technologies help reduce air pollution and greenhouse gas emissions, making buses more sustainable compared to traditional diesel vehicles. However, the use of alternative fuels also creates new engineering challenges, especially in relation to vehicle safety and structural design. One important issue is the strength of the bus roof. In many CNG and fuel cell buses, heavy storage tanks or fuel cell systems are installed on the roof. This additional load changes how forces are distributed across the vehicle and may influence how the structure behaves during accidents, such as rollovers. Ensuring that the roof can safely carry these components while still protecting passengers is therefore a critical part of bus design. This paper examines the conditions that affect roof structure strength in buses powered by CNG. It focuses on how roof-mounted components influence mechanical performance, safety compliance, and overall reliability. The regulations UN ECE 110R and UN ECE 115R more closely define the technical requirements for the installation and homologation of natural gas devices and equipment. The aim of presented researches is to contribute to the development of safer and more efficient bus designs that support sustainable public transport. The presented calculation methods are also applicable to fuel cell and battery electric buses.
This paper presents the strain-smoothed element (SSE) method applied to the 4-node tetrahedral finite element. The unique characteristic of the SSE method represents constructing a smoothed strain field for the elements, rather than for the smoothing domains, whereby the constant strains of all adjacent elements are fully utilized for the strain smoothing of the target element. Consequently, a linear strain field within the 4-node tetrahedral finite element is constructed through four Gauss integration points. The method does not require any additional creation of the mesh, and a standard isoparametric formulation of the 4-node tetrahedral finite element is used to formulate it. A numerical example was used to demonstrate the stress prediction improvement achieved as regards the corrected element, as taken from Chaemin Lee and Phill-Seung Lee’s publication of the method itself, compared with the linear and quadratic tetrahedral finite elements, which are implemented within the PAK and Simcenter Nastran software packages. The numerical results show that stresses predicted by the strain-smoothed 4-node tetrahedral finite element are comparable to that of a 10-node tetrahedral finite element that incorporates an extrapolation process for the determination of nodal stress values.