In multiphase electric machines, high-performance control strategies require suitable electrical parameter estimation. This aspect is particularly true for the class of multiphase machines known as variable phase-pole induction machines. This work analyzes, calculates, and experimentally validates different parameter estimation methods for a wound independently-controlled stator coil induction machine, which can dynamically change the phase-pole configuration during real-time operation. The parameter estimation methods are a conventional finite-element analysis-based stator impedance calculation and an implementation of the harmonic plane decomposition theory. Experimental verification illustrates the proposed estimation technique in different machine configurations. Comparing the two analyzed methods, the estimation of all machine parameters based on the harmonic plane decomposition theory well agrees with the practical results. The results indicate that using the proposed method as the initial parameter estimate in a commissioning process for a variable phase-pole drive is possible and beneficial for the reduced computing time.
In this paper, an hourly dispatch model was developed to analyze the system balancing and wind power curtailment challenges in the future of the Ethiopian electric power grid system. The developed model was validated using historical data and was used for the analysis of the grid system in 2030 with different scenarios. The model was used to examine the impacts of transmission capacity, regulation reserve requirement, and daily minimum generation of hydropower for irrigation with three cases of wind annual energy share of 14.5%, 17.8%, and 25.2%. Thus, the curtailment was found to be below 0.2%, 1.1%, and 9.8% for each case, respectively. The cost of wind energy increases in proportion to the percentage of curtailment and the increase in transmission line capacity. Reducing the minimum hydropower generation results in smaller wind power curtailment and better generation–consumption balancing.
Power transmission lines in Ethiopia are experiencing an alarmingly high frequency of unexplained outages triggered by environmental factors, which significantly undermine the reliability of the country’s power system. This paper presents investigations aiming to identify those among the unexplained fault records that have been caused by pollution induced flashovers. An identification method is developed, which associates the contextual fault features, such as information about the characteristics of the fault, fault location, and time of day, as well as month of its occurrence with local meteorological/climatic and environmental conditions. A total number of 4231 unexplained faults, recorded between 2015 and 2022, were analyzed. Among them, 1045 faults (24.7%) were identified as being most likely caused by pollution induced flashovers. The entire network suffered from more than 130 pollution-induced flashovers annually with a frequency of about 0.8 faults/100 km/year. The fault frequency strongly differed among the grid regions, being highest in the Northeast and lowest in the Southwest region. Moreover, the performed analyses also concentrated on the evaluation of the pollution performance of various insulator types employed in the network. The results indicate that porcelain insulators have the highest pollution-induced flashover intensity of 1.47 faults/year/1000 units, followed by silicone rubber polymeric composite insulators and glass insulators with the respective intensities of 1.21 and 0.83 faults/year/1000 units. These results indicate that despite the high expectations towards the pollution performance of silicone rubber polymeric insulators, their use in the Ethiopian climatic and environmental conditions appears to be unsatisfactory.
20 May 2025 in IEEE Transactions on Energy Conversion
Variable phase-pole induction machines appear to offer the potential for use in electromobility applications due to their capability of electronically changing the number of magnetic poles, thus extending the torque-speed operation of the machine. This work presents a model reference adaptive system solution for the sensorless speed operation of a nine-phase variable phase-pole induction machine. The same adaptive fullorder observer is used to estimate the mechanical speed in two different ways, one for each pole pair configuration of interest. The sensorless operation of the drive is maintained during the pole-pair configuration change with a suitable transition between the two speed-estimation laws, guaranteeing precise rotor flux linkage information for achieving high-performance control. The simulation and experimental results of the proposed method demonstrate a high degree of agreement, indicating the effectiveness of the proposed sensorless methodology under varying load conditions and positive/negative speed transitions.