Muldi Yuhendri

Dr. Muldi Yuhendri

orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2018 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Verified
Journal Article
Open access
PDF file
MYMuldi Yuhendri
Muldi Yuhendri
AAAhyanuardi Ahyanuardi
Ahyanuardi Ahyanuardi
AAAswardi Aswardi
Aswardi Aswardi
Matrix converter is a good choice for Permanent Magnet Synchronous Motor (PMSM) drives, because it has high power density and does not require dc-link energy storage. the disadvantages of conventional matrix converter is using 18 active switches, so it becomes expensive and the modulation method becomes more complicated than back to back converter. To minimize this problem, this paper proposes variable speed drive of PMSM using Ultra Sparse Matrix Converter (USMC) based on Direct Torque Control (DTC) methods. This converter uses only 9 active switches, making it cheaper than conventional matrix converter. DTC is designed based on Space Vector Modulation (SVM) to reduce torque and flux ripples due to the hysteresis control in conventional DTC. The simulation results show that DTC based SVM using USMC effectively controls the rotor speed with low torque and flux ripples.

1 February 2025 in Indonesian Journal of Electrical Engineering and Computer Science
Verified
Journal Article
Open access
PDF file
YSYulianta Siregar
Yulianta Siregar
YSYosephine Rotua Oktaviana Siahaan
Yosephine Rotua Oktaviana Siahaan
NMNur Nabila Binti Mohamed
Nur Nabila Binti Mohamed
DRDedet Candra Riawan
Dedet Candra Riawan
MYMuldi Yuhendri
Muldi Yuhendri
The problem with 3-phase induction motors is that when starting the motor, the motor starting current can reach five to seven times the nominal current. This research compares slip, starting current, bus voltage, acceleration torque, motor torque, energy savings, and kVAR from the direct on-line (DOL), variable frequency drive (VFD), soft starting, and autotransformer starting methods in the electrical transient analyzer program (ETAP) software. This research result shows that the fastest VFD slip reaches a steady state, namely at 11+ seconds. The lowest starting/starting current is owned by the VFD method, namely <20% full load amps (FLA) in the first 2 seconds. The lowest decrease in bus voltage at steady state was experienced by the VFD method, namely 0.8152%. The quickest acceleration torque reaches a steady state in the VFD method, namely in 11+ seconds. The soft starting method owns the lowest starting torque, namely 20.75%. The soft starting method has the largest energy savings, namely 148.02 kW. Of the several variables observed, the best starting method is the VFD method.

1 August 2011 in TELKOMNIKA (Telecommunication Computing Electronics and Control)
Verified
Journal Article
Open access
PDF file
MYMuldi Yuhendri
Muldi Yuhendri
MAMochamad Ashari
Mochamad Ashari
MPMauridhi Hery Purnomo
Mauridhi Hery Purnomo
Maximum Output Power Tracking of Wind Turbine Using Intelligent Control

1 July 2020 in Journal of Physics: Conference Series
Verified
Conference Paper
Open access
MYMuldi Yuhendri
Muldi Yuhendri
RIRisfendra
Risfendra
MMMukhlidi Muskhir
Mukhlidi Muskhir
HAHambali
Hambali
Super chicken is one type of chicken that began to be developed to get better meat with a faster harvest. Super native chicken seedlings can be obtained from broiler broodstocks with males from native chickens. In this paper, an automatic egg incubator is proposed to increase the productivity of super native chicken seedlings developed in Nagari Salareh Aia. This egg incubator can hold 200 chicken eggs with a heater using 8 pieces of 5 watt incandescent lamps. This tool is also equipped with a thermostat for automatic temperature regulation and a motor for moving the egg rack. Due to the low reliability of the electricity network in this area, the egg incubator is supplied with a 300 wp solar panel equipped with a 200 Ah battery to maintain electrical power continuity. The experimental results show that this egg incubator has worked well as expected.

1 December 2019 in Bulletin of Electrical Engineering and Informatics
Verified
Journal Article
Closed access
PDF file
MYMuldi Yuhendri
Muldi Yuhendri
MMMukhlidi Muskhir
Mukhlidi Muskhir
TTTaali Taali
Taali Taali
Variable speed control of wind turbine generator systems have been developed to get maximum output power at every wind speed variation, also called Maximum Power Points Tracking (MPPT). Generally, MPPT control system consists of MPPT algorithm to track the controller reference and generator speed controller. In this paper, MPPT control system is proposed for low speed wind turbine generator systems (WTGs) with MPPT algorithms based on optimum tip speed ratio (TSR) and generator speed controller based on field oriented control using type-2 fuzzy system (T2FS). The WTGs are designed using horizontal axis wind turbines to drive permanent magnet synchronous generators (PMSG). The simulation show that the MPPT system based optimum TSR has been able to control the generator output power around the maximum point at all wind speeds.

4 June 2025 in Engineering, Technology & Applied Science Research
Verified
Journal Article
Open access
PDF file
MYMuldi Yuhendri
Muldi Yuhendri
JSJulianta Siregar
Julianta Siregar
DRDeded Candra Riawan
Deded Candra Riawan
NMNur Nabila Mohamed
Nur Nabila Mohamed
TATaali
Taali
FHFatimah Hanifah
Fatimah Hanifah
Electric motors, which are widely used in industry, need to be controlled and monitored to ensure that they operate as intended. With the development of Internet of Things (IoT) technology, electric motors can be remotely controlled and accurately monitored in real time. This paper proposes an IoT-based supervised control of a three-phase Squirrel Cage Induction Motor (SCIM) using a Variable Speed Drive (VSD) module and a Programmable Logic Controller (PLC) as a control device with several display screens, namely Human Machine Interface (HMI), PC server, and PC client. This allows the electric motor to be remotely controlled and monitored via the internet by a motor control system implemented using the vector control method available in the VSD module. The proposed method has been verified through laboratory experiments, and the experimental results demonstrate that the IoT-based supervised control system of the induction motor works as designed. The motor rotation speed and direction can be successfully controlled and monitored according to the reference using the HMI, PC server, and PC client.