The new actual scientific direction is in the development of different nanocomposites and the study of their medical–biological, physicochemical, and physicomechanical properties. One way to expand the functionality of nanocomposites and nanomaterials is to introduce carbon nanostructures into the polymer matrix. This study presents the properties of unsaturated polyester resins (Estromal, LERG S.A.) based on PET recyclate with multi-walled carbon nanotubes (MWCNTs): their mechanical and thermomechanical characteristics, resistance to ultraviolet radiation (UV-vis), and chemical resistance properties. The properties of the obtained materials were characterized using physical–chemical research methods. The changes in the properties of the composites for MWCNT content of 0.1, 0.3, and 0.5 wt % were determined. The results showed positive influences on the thermomechanical and mechanical properties of nanocomposites without significant deterioration of their gloss. Too much CNT added to the resin leads to heterogeneity of the composite structure.
The creation of heat-resistant polymers represents one of the most significant challenges and priorities in contemporary scientific research. The incorporation of a filler of analogous nature and content into disparate types of resins will facilitate the identification of the relationship between properties and the structure of macromolecular chains in synthetic resins that function as composite matrices. The objective of this study was to ascertain the impact of lignin at 5 and 15% by weight on the thermal degradation of two resin-based composites with disparate structural compositions. The thermal decomposition products of the composites were determined by the method of temperature-programmed desorption mass spectroscopy (TPD MS). The thermal oxidative degradation patterns of polymer composites were investigated through derivatography (Q–1500D). It was demonstrated that the incorporation of lignin in modest quantities has a negligible impact on the thermal stability of the composites. Notably, the temperature at which the composites undergo thermal decomposition during thermal oxidation degradation exhibits a variation of over 10 °C, suggesting that the utilisation of lignin holds promise for the development of environmentally benign and cost-effective materials for diverse industrial applications.
18 February 2015 in Journal of Applied Polymer Science
Multilayered graphene nanoplatelets (MLGs) were prepared from thermally expanded graphite flakes using an electrochemical technique. Morphological characterization of MLGs was performed using scanning electron microscopy (SEM), X-ray diffraction analysis (XRD), Raman spectroscopy (RS), and the Brunauer–Emmett–Teller (BET) method. DGEBA-epoxy-based nanocomposites filled with synthesized MLGs were studied using Static Mechanical Loading (SML), Thermal Desorption Mass Spectroscopy (TDMS), Broad-Band Dielectric Spectroscopy (BDS), and Positron Annihilation Lifetime Spectroscopy (PALS). The mass loading of the MLGs in the nanocomposites was varied between 0.0, 0.1, 0.2, 0.5, and 1% in the case of the SML study and 0.0, 1.0, 2, and 5% for the other measurements. Enhancements in the compression strength and the Young’s modulus were obtained at extremely low loadings ( 0.01%). An essential increase in thermal stability and a decrease in destruction activation energy were observed at 5%. Both the dielectric permittivity () and the dielectric loss factor () increased with increasing over the entire frequency region tested (4 Hz–8 MHz). Increased is correlated with decreased free volume when increasing . Physical mechanisms of MLG–epoxy interactions underlying the effects observed are discussed.
30 September 2020 in Himia, Fizika ta Tehnologia Poverhni