This paper presents an analysis of the test results of mechanical properties of masonry walls. As part of the planned research the main goal is to determine the compressive strength, elasticity modulus, shear modulus, and the characteristic steadiness on the tensile of the masonry walls. Experimentally determined values for the modulus of elasticity of the tested walls are higher than those provided in regulations PIOVS’91, EN 1996-1-1: 2005; ACI 530. Values of characteristic compressive strength obtained analytically and based on equations that are given in national and international standards are larger than the values of the characteristic compressive strengths of the walls that we have examined. This study is relevant for Montenegro, which is a seismically dangerous zone
The extreme river streamflow that occurred during floods in 2010 in Montenegro caused significant damage to infrastructure and road facilities. The most severe damages were located on bridges crossing the river Lim, where a rapid water level increase in several municipalities led to failure or damage of almost 20 bridges. In this paper, a damage assessment of four significantly damaged reinforced concrete (RC) bridges, located in the affected zone of 40 km, is conducted. One bridge in Berane (bridge 1) and three bridges located on roads upstream from Berane (bridges 2, 3, and 4) were analyzed. Extreme water levels and inadequate flow profiles caused great damage to the bridges of which the piers were not adequately founded. A scouring process under the foundation of piers and abutments located in the riverbed occurred due to surface erosion and degradation of alluvial sediments. Applied methods and techniques for reconstruction and structural strengthening of bridges are presented in detail as well as results of conducted analyses of the design reconstruction process. In order to design appropriate structural strengthening, nonlinear analyses of bridges due to the settlement of the piers were performed. The research findings can be used in the vulnerability assessment and reconstruction planning phases for other bridges in the considered zone.
This paper will present testing of masonry walls made from clay block and concrete block. Experimental testing of the walls is done in the laboratory of the University of Civil Engineering in Podgorica within the national scientific research project "Seismic risk reduction in buildings of stone and brick". This paper presents the results of testing samples of walls built with the tested masonry elements and mortar. Characteristic compressive strength of the walls and elasticity modules were obtained. An analytical approach to determining the characteristic compressive strength and elasticity modules of masonry walls is analyzed in accordance with the applicable standard of Yugoslavia PIOVS'91, European standards EN 1996-1-1: 2005 and the American standard ACI 530.