The catalytic performance of Ce- and La-promoted Ni/SBA-15 catalysts for syngas production from CO2 reforming of methane has been investigated in a fixed-bed reactor at stoichiometric feed composition. Both promoted and unpromoted catalysts possessed high BET surface area of 303-445 m2 g-1. Additionally, SBA-15 support had a relatively uniform rod-like shape with a diameter of about 0.55 μm and a reduction in the crystallite size of NiO phase from 27.0 to 19.1 nm was observed with promoter\ud addition reasonably due to the strong interaction between promoter and NiO particles. CeO2 and La2O3 dopants were finely dispersed on catalyst surface. Temperature-programmed oxidation of spent catalysts showed that coke-resistance was improved significantly with promoter modification and 3%La-10%Ni/SBA-15 catalyst was the most resistant to carbonaceous deposition rationally due to the least NiO crystallite size hindering the nucleation and growth of graphitic carbon. Hence, La-promoted catalyst appeared to be the optimum catalyst in terms of reactant conversion, H2 yield and stability whilst a gradual decline in both reactant conversion and H2 yield was experienced with unpromoted and Ce-doped catalysts. Regardless of catalyst types, the ratio of H2 to CO was always less than unity preferred for Fischer-Tropsch synthesis
CO2 methanation was studied on Ni-based yttria-stabilised zirconia (Ni/YSZ) catalysts. The catalysts were prepared by the wet impregnation method, where the amount of Ni content was varied from 5% to 75%. Thereafter, the prepared catalysts were analysed by BET, XRD, SEM and H2-TPR. BET results showed an initial increase in the surface area with an increase in Ni loading, then a decrease after 30% Ni loading. The XRD results revealed that the Ni crystallite size increased as the Ni loading increased, while the H2-TPR showed a shift in reduction peak temperature to a higher temperature, indicating that the reducibility of the catalysts decreased as the Ni loading increased. The activity of the synthesised catalysts for CO2 methanation was studied by passing a mixture of H2, CO2 and N2 with a total flow of 135 mL min−1 and GHSV of 40,500 mL h−1 g−1 through a continuous flow quartz tube fixed-bed reactor (I.D. = 5.5 mm, wall thickness = 2 mm) containing 200 mg of the catalyst at a temperature range of 473 to 703 K under atmospheric pressure and a H2:CO2 ratio of 4. The tested Ni/YSZ catalysts showed an improvement in activity as the reaction temperature increased from 473 K to around 613 to 653 K, depending on the Ni loading. Beyond the optimum temperature, the catalyst’s activity started to decline, irrespective of the Ni loading. In particular, the 40% Ni/YSZ catalyst displayed the best performance, followed by the 30% Ni/YSZ catalyst. The improved activity at high Ni loading (40% Ni) was attributed to the increase in hydrogen coverage and improved site for both H2 and CO2 adsorption and activation.
This paper presents steady-state simulation and exergy analysis of the 2-amino-2-methyl-1-propanol (AMP)-based post-combustion capture (PCC) plant. Exergy analysis provides the identification of the location, sources of thermodynamic inefficiencies, and magnitude in a thermal system. Furthermore, thermodynamic analysis of different configurations of the process helps to identify opportunities for reducing the steam requirements for each of the configurations. Exergy analysis performed for the AMP-based plant and the different configurations revealed that the rich split with intercooling configuration gave the highest exergy efficiency of 73.6%, while that of the intercooling and the reference AMP-based plant were 57.3% and 55.8% respectively. Thus, exergy analysis of flowsheeting configurations can lead to significant improvements in plant performance and lead to cost reduction for amine-based CO2 capture technologies.