Shaoqiu Zhang

Mr. Shaoqiu Zhang

insitute of disaster prevention
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 June 2023 in Geomechanics and Geophysics for Geo-Energy and Geo-Resources
Verified
Journal Article
Open access
PDF file
XHXin Huang
Xin Huang
XCXiaoguang Cai
Xiaoguang Cai
PYPan Yang
Pan Yang
XZXuexin Zheng
Xuexin Zheng
SZShaoqiu Zhang
Shaoqiu Zhang
JBJingshan Bo
Jingshan Bo
The increase of pore water pressure under a dynamic load is an important reason for the vibration liquefaction of saturated sand. Therefore, studying the dynamic pore water pressure model of tailings sand plays an important role in the seismic liquefaction analysis of tailings ponds. In this paper, the dynamic pore water pressure development characteristics of tailings fine sand and tailings silt in a tailings pond with the centerline method are studied by dynamic triaxial tests. The research results show that the liquefaction dynamic pore pressure ratio of tailings fine sand shows a trend of "rising–smooth–rising" with increasing vibration frequency ratio, and the liquefaction dynamic pore-pressure ratio of tailings silt shows an approximate linear and stable increasing trend. According to the development law of dynamic pore pressure, a new tailings sand pore pressure stress model is proposed in this paper, and the fitting effect is compared with four different pore pressure models, which verifies the applicability of the new model to predict the growth of dynamic pore pressure in tailings and silt.

8 August 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
HXHonglu Xu
Honglu Xu
XCXiaoguang Cai
Xiaoguang Cai
HWHaiyun Wang
Haiyun Wang
SLSihan Li
Sihan Li
XHXin Huang
Xin Huang
SZShaoqiu Zhang
Shaoqiu Zhang
A series of shaking table tests were carried out to explore the dynamic characteristics and working mechanisms of wrapped-face reinforced soil-retaining walls under strong vibration. Under the 0.1–1.0 g horizontal peak ground acceleration (HPGA), the damping ratio of sand shows a downward trend as a whole, so the acceleration amplification coefficient decreases with the increase of HPGA. However, when HPGA reaches 1.0 g, the acceleration amplification coefficient increases; the range of acceleration amplification coefficient at the top of the wall is 1.69–1.36. When HPGA is 1.0 g, the maximum cumulative residual displacement of the panel is 2.96% H, and the maximum uneven settlement of the sand is 3.57% H, both of which have exceeded the limit of the specification. With the increase of HPGA, the ratio of the dynamic earth force increment to the total dynamic earth force gradually approaches 50%. Since the reinforcement effect of geogrid is not considered, the predicted value of traditional earth pressure theory is different from the measured value. According to the Washington State Department of Transportation displacement index, the deformation range of wrapped-face reinforced soil-retaining walls is divided into three stages: the quasi-elastic stage, the plastic stage, and the failure stage.

6 December 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
XCXiaoguang Cai
Xiaoguang Cai
SZShaoqiu Zhang
Shaoqiu Zhang
SLSihan Li
Sihan Li
HXHonglu Xu
Honglu Xu
XHXin Huang
Xin Huang
XLXin Liu
Xin Liu
A series of shaking table tests was carried out on the dynamic performance and working mechanism of a gabion reinforced soil retaining wall under seismic load. The test results show that the panel presents the deformation mode of middle and upper bulging at the contact point between the rigid box and the retaining wall The settlement of top backfill is relatively uniform, and there is basically no differential settlement, the natural frequencies at different positions and heights inside the retaining wall are basically the same, and the natural frequencies are stable between 22.61 and 23.04 Hz below 0.8 g. The damping ratio decreases with the increase in wall height, and the damping ratio at each stage after vibration is greater than that before vibration. The seismic earth pressure is nonlinearly distributed. The measured value of the lower part of the retaining wall is smaller than that calculated by the Seed–Whitman method with an increase in peak acceleration, and the measured value of the upper part of the retaining wall is larger than the theoretical calculation results. The position of the resultant action point of seismic earth pressure is greater than 0.33 times the wall height specified by the Mononobe–Okabe method.

17 September 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
XCXiaoguang Cai
Xiaoguang Cai
SZShaoqiu Zhang
Shaoqiu Zhang
SLSihan Li
Sihan Li
HXHonglu Xu
Honglu Xu
XHXin Huang
Xin Huang
CZChen Zhu
Chen Zhu
Most of the damage to reinforced retaining walls is caused by excessive deformation; however, there is no calculation method for deformation under static and dynamic loads in the design codes of reinforced soil retaining walls. In this paper, by collecting the measured displacement data from four actual projects, four indoor prototype tests and two indoor model tests under a total of 10 static load conditions, and comparing the calculation results with seven theoretical methods, the results show that the FHWA method is more applicable to the permanent displacement prediction of indoor prototype tests and that the CTI method is more applicable to the permanent displacement prediction of actual projects and indoor model tests. Two yield acceleration calculation methods and four permanent displacement calculation formulas were selected to calculate the displacement response of two reinforced soil test models under seismic loads and compared with the measured values, and the results showed that the Ausilio yield acceleration solution method was better. When the input peak acceleration ranges from 0.1 to 0.6 g, the Richards and Elms upper limit method is used, and when the input peak acceleration is 0.6–1.0 g, the Newmark upper limit method can predict the permanent displacement of the retaining wall more accurately.