Xiaoguang Cai

Prof. Dr. Xiaoguang Cai

insitute of disaster prevention
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 August 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
HXHonglu Xu
Honglu Xu
XCXiaoguang Cai
Xiaoguang Cai
HWHaiyun Wang
Haiyun Wang
SLSihan Li
Sihan Li
XHXin Huang
Xin Huang
SZShaoqiu Zhang
Shaoqiu Zhang
A series of shaking table tests were carried out to explore the dynamic characteristics and working mechanisms of wrapped-face reinforced soil-retaining walls under strong vibration. Under the 0.1–1.0 g horizontal peak ground acceleration (HPGA), the damping ratio of sand shows a downward trend as a whole, so the acceleration amplification coefficient decreases with the increase of HPGA. However, when HPGA reaches 1.0 g, the acceleration amplification coefficient increases; the range of acceleration amplification coefficient at the top of the wall is 1.69–1.36. When HPGA is 1.0 g, the maximum cumulative residual displacement of the panel is 2.96% H, and the maximum uneven settlement of the sand is 3.57% H, both of which have exceeded the limit of the specification. With the increase of HPGA, the ratio of the dynamic earth force increment to the total dynamic earth force gradually approaches 50%. Since the reinforcement effect of geogrid is not considered, the predicted value of traditional earth pressure theory is different from the measured value. According to the Washington State Department of Transportation displacement index, the deformation range of wrapped-face reinforced soil-retaining walls is divided into three stages: the quasi-elastic stage, the plastic stage, and the failure stage.

1 January 2021 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
XCXiaoguang Cai
Xiaoguang Cai
SLSihan Li
Sihan Li
HXHonglu Xu
Honglu Xu
LJliping jing
liping jing
XHXin Huang
Xin Huang
CZChen Zhu
Chen Zhu
This study presents experimental results from shaking table tests on a reduced‐scale geogrid reinforced soil retaining wall (RSRW) to investigate the seismic response of the fundamental frequency, acceleration amplification, face displacement, backfill surface settlement, and reinforcement strain under different peak accelerations and durations. The fundamental frequency is in good agreement with the predicted values. The root mean square (RMS) acceleration amplification factors increase nonlinearly with the wall height and decrease with increasing seismic load, which is not regarded as a constant value. The distributions of the peak displacement are consistent with those of the residual displacement. The combination of the sliding and rotation is observed as the predominant mode of displacement, and the rotation mode is dominant. The positions near the face (35 cm) and the ends of the reinforcement (140 cm) demonstrated larger settlement than that of the central position (70 cm and 105 cm). The reinforcement strain increased with increasing peak acceleration and maximum values measured at the central layers. The trends of the potential failure surface are similar to those of the 0.3H bilinear failure surface. The friction coefficient is nonlinearly distributed along with the reinforcements, and the maximum friction coefficient appears at the top layer (F11).

20 August 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
XCXiaoguang Cai
Xiaoguang Cai
JFJiayu Feng
Jiayu Feng
SLSihan Li
Sihan Li
HXHonglu Xu
Honglu Xu
WLWeiwei Liu
Weiwei Liu
XHXin Huang
Xin Huang
The interaction between reinforcement and soil is a key problem in the application of geosynthetics as reinforcement in geotechnical engineering. In this study, tensile and pull-out tests on a uniaxial geogrid were carried out using self-designed tensile and pull-out test equipment. The tensile test evaluated the tensile load–strain characteristics of a geogrid. Under the condition of lateral confinement, the tensile force and secant tensile stiffness of the geogrid increased with an increase in the normal stress when the strain was constant, and the secant tensile stiffness decreased with a decrease in the tensile rate. The stiffness coefficient was used to quantitatively describe the change in the stiffness of the reinforcement. Using the pull-out test, the variation laws of the pull-out force of the geogrid under different normal stresses and different longitudinal rib percentages were obtained. When the geogrid was broken, the pull-out force of the same type of geogrid was not significantly different under different normal stresses. With an increase in the longitudinal rib percentage, the pull-out force of the geogrid under the same normal stress gradually increased, and the apparent friction coefficient was obtained by analysis. The results of the apparent friction coefficient obtained by the analytical method in accordance with French specifications (NF P94-270-2020) are relatively safe compared to the experimental values.

6 December 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
XCXiaoguang Cai
Xiaoguang Cai
SZShaoqiu Zhang
Shaoqiu Zhang
SLSihan Li
Sihan Li
HXHonglu Xu
Honglu Xu
XHXin Huang
Xin Huang
XLXin Liu
Xin Liu
A series of shaking table tests was carried out on the dynamic performance and working mechanism of a gabion reinforced soil retaining wall under seismic load. The test results show that the panel presents the deformation mode of middle and upper bulging at the contact point between the rigid box and the retaining wall The settlement of top backfill is relatively uniform, and there is basically no differential settlement, the natural frequencies at different positions and heights inside the retaining wall are basically the same, and the natural frequencies are stable between 22.61 and 23.04 Hz below 0.8 g. The damping ratio decreases with the increase in wall height, and the damping ratio at each stage after vibration is greater than that before vibration. The seismic earth pressure is nonlinearly distributed. The measured value of the lower part of the retaining wall is smaller than that calculated by the Seed–Whitman method with an increase in peak acceleration, and the measured value of the upper part of the retaining wall is larger than the theoretical calculation results. The position of the resultant action point of seismic earth pressure is greater than 0.33 times the wall height specified by the Mononobe–Okabe method.

21 November 2024 in Transportation Geotechnics
Verified
Journal Article
Closed access
CZChen Zhu
Chen Zhu
XCXiaoguang Cai
Xiaoguang Cai
YLYurun Li
Yurun Li
SLSihan Li
Sihan Li
XHXin Huang
Xin Huang
HXHonglu Xu
Honglu Xu

29 October 2020 in Shock and Vibration
Verified
Journal Article
Open access
PDF file
SLSihan Li
Sihan Li
XCXiaoguang Cai
Xiaoguang Cai
LJliping jing
liping jing
HXHonglu Xu
Honglu Xu
XHXin Huang
Xin Huang
CZChen Zhu
Chen Zhu
This paper presents experimental results from shaking table tests on two reduced-scale geogrid reinforced soil-retaining walls (RSRWs) constructed using standard soil, modular facing blocks, and uniaxial geogrid reinforcement to investigate the distribution of the geogrid strain and the mode of potential failure surface for dynamic loading conditions. Similitude relationships for shaking table tests in a 1 g gravitational field were used to scale the specimen geometry, applied characteristics of the earthquake motions. The lateral displacement of the top model is sufficiently large for the top-model block to fall down, and the RSRW is thus destroyed. The tensile strain at the lower part is greater than that at the upper part of the RSRW. The tensile strain in different layers for two-tiered RSRW is consistent with single-step RSRW. On comparing the measured maximum tensile strain lines of the geogrid with the result of the existing calculation method of the potential failure surface, it can be observed that the existing partial calculation method is conservative. Based on the calculation methods of various potential failure surfaces and the measured data, the use of a two-tiered fold-line failure surface is proposed for the two-tiered RSRW while taking into consideration the width of the platform. And it is advised that the failure surface calculation method of BS8006 be used as the calculation method for the potential failure surface of the single-step RSRW under dynamic motion.