The growing demand for reliable micropower sources in extreme environments has accelerated the development of betavoltaic cells (BV cells) with high energy conversion efficiency and superior radiation resistance. This study demonstrates an advanced BV cell architecture utilizing three-dimensional TiO2 nanorod arrays (TNRAs) integrated with a NiOx hole transport layer (HTL). Monte Carlo simulations were employed to optimize the cell design and determine the fabrication parameters for growing TNRAs on FTO substrates via hydrothermal synthesis. The performance evaluation employed both electron beam (2.36 × 109 e/cm2·s) and 63Ni (3.4 mCi/cm2) irradiation methods. The simulation results revealed optimal energy deposition characteristics, with ~96% of β-particle energy effectively absorbed within the 2 μm thick FTO/TNRA/NiOx/Au structure. The NiOx-incorporated device achieved an energy conversion efficiency of 4.84%, with a short-circuit current of 119.9 nA, an open-circuit voltage of 324.2 mV, and a maximum power output of 24.0 nW, representing a 3.76-fold enhancement over HTL-free devices. Radioactive source testing confirmed stable power generation and linear efficiency scaling, validating electron beam irradiation as an effective accelerated testing methodology for BV cell research.
MoS2, a typical transition metal dichalcogenide, features a layered structure, multi-phase transition, and tunable band gap, which is a promising candidate for aqueous zinc-ion batteries (AZIBs). Recent studies have focused on the metastable 1T-MoS2 phase, which exhibits superior electrical conductivity and electrochemical activity compared to the more stable 2H phase. Herein, a straightforward one-step hydrothermal method was used to synthesize three-dimensional MoS2/polymer composites (H-MoS2-PEDOT). Under acidic conditions, the polymerization and intercalation of EDOT molecules in the MoS2 layers promote the phase transition from 2H to 1T, thereby enhancing its conductivity and electrochemical performance. Additionally, it was found that the intercalated PEDOT and small amounts of water molecules have contributed to enhancing Zn2+ ion diffusion and cycle stability. As a result, AZIBs based on the H-MoS2-PEDOT composite deliver a high specific capacity of 173.6 mAh g−1 at 1 A g−1, maintaining a specific capacity of 116 mAh g−1 and a capacity retention of 82.8% after 1000 cycles at 5 A g−1.
6 February 2026 in International Journal of Modern Physics B
The performance of radio-photovoltaic cells (RPVCs) depends on the radiation source, energy deposition, and radioluminescence collection. This study examines a waveguide light-concentration array (WLCA) composed of GAGG:Ce columns with radiation source material loaded into the inter-column gaps. The array increases the interfacial area between the source and the scintillator and allows irradiation from several directions. A source-thickness scan identifies 120 μm as a candidate near the plateau of the emitted-electron yield. In the structural calculations with 120 μm gaps, approximately 31.8% and 75.8% of the initial energy is deposited in GAGG:Ce for representative 90Sr and 90Y electron energies, respectively. The 90Sr deposited-energy fraction increases from approximately 16.2% in the conventional sandwich (CS) structure to 31.8% in the WLCA. Compared with the CS structure, the WLCA increases source-energy utilization efficiency by 96.3%. In addition, the radioluminescence emission of the WLCA structure is superior to that of the CS structure, while the photon emission is more concentrated. These results identify the WLCA structure as a promising strategy for improving radio-photovoltaic energy conversion and extending the applicability of long-life isotope power sources.