Vaishali Swaminathan

Dr. Vaishali Swaminathan

Biological and Agricultural Engineering, Texas A&M University, College Station, Texas, USA
+1

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 December 2020 in Sensors
Verified
Journal Article
Open access
PDF file
Xiongzhe HanXiongzhe Han
Xiongzhe Han
ATAlex Thomasson
Alex Thomasson
VSVaishali Swaminathan
Vaishali Swaminathan
Tianyi WangTianyi Wang
Tianyi Wang
JSJeffrey Siegfried
Jeffrey Siegfried
HNHaly Neely
Haly Neely
Accurate and reliable calibration methods are required when applying unmanned aerial vehicle (UAV)-based thermal remote sensing in precision agriculture for crop stress monitoring, irrigation planning, and harvesting. The primary objective of this study was to improve the calibration accuracies of UAV-based thermal images using temperature-controlled ground references. Two temperature-controlled ground references were installed in the field to serve as high- and low-temperature references, approximately spanning the expected range of crop surface temperatures during the growing season. Our results showed that the proposed method using temperature-controlled references was able to reduce errors due to ambient conditions from 9.29 to 1.68 °C, when tested with validation panels. There was a significant improvement in crop temperature estimation from the thermal image mosaic, as the error reduced from 14.0 °C in the un-calibrated image to 1.01 °C in the calibrated image. Furthermore, a multiple linear regression model (R2 = 0.78; p-value < 0.001; relative RMSE = 2.42%) was established to quantify soil moisture content based on canopy surface temperature and soil type, using UAV-based thermal image data and soil electrical conductivity (ECa) data as the predictor variables.

2 March 2020 in Inventions
Verified
Journal Article
Open access
PDF file
Xiongzhe HanXiongzhe Han
Xiongzhe Han
ATAlex Thomasson
Alex Thomasson
Tianyi WangTianyi Wang
Tianyi Wang
VSVaishali Swaminathan
Vaishali Swaminathan
Ground control points (GCPs) are critical for agricultural remote sensing that require georeferencing and calibration of images collected from an unmanned aerial vehicles (UAV) at different times. However, the conventional stationary GCPs are time-consuming and labor-intensive to measure, distribute, and collect their information in a large field setup. An autonomous mobile GCP and a collaboration strategy to communicate with the UAV were developed to improve the efficiency and accuracy of the UAV-based data collection process. Prior to actual field testing, preliminary tests were conducted using the system to show the capability of automatic path tracking by reducing the root mean square error (RMSE) for lateral deviation from 34.3 cm to 15.6 cm based on the proposed look-ahead tracking method. The tests also indicated the feasibility of moving reflectance reference panels successively along all the waypoints without having detrimental effects on pixel values in the mosaicked images, with the percentage errors in digital number values ranging from −1.1% to 0.1%. In the actual field testing, the autonomous mobile GCP was able to successfully cooperate with the UAV in real-time without any interruption, showing superior performances for georeferencing, radiometric calibration, height calibration, and temperature calibration, compared to the conventional calibration method that has stationary GCPs.

2 September 2017 in Water
Verified
Journal Article
Open access
PDF file
KBKyna Borel
Kyna Borel
VSVaishali Swaminathan
Vaishali Swaminathan
CVCherish Vance
Cherish Vance
GRGalen Roberts
Galen Roberts
Raghavan SrinivasanRaghavan Srinivasan
Raghavan Srinivasan
RKRaghupathy Karthikeyan
Raghupathy Karthikeyan
In the United States, pathogens are the leading cause for rivers and streams to exceed water quality standards. The Spatially Explicit Load Enrichment Calculation Tool (SELECT) was developed to estimate bacterially contaminated water bodies based on spatial factors such as land use, soil, and population density. SELECT was originally automated using Visual Basics for Applications (VBA), which is no longer supported by the current version of ArcGIS. The aim of this research was to develop a new SELECT interface, pySELECT, using the Python programming language and to incorporate a rainfall-runoff E. coli transport module to simulate E. coli loads resulting from urban sources, such as dogs and on-site wastewater treatment systems. The pySELECT tool was applied to Lavon Lake, a semi urban study watershed in Northeast Texas. The highest potential E. coli loads were in the areas closest to the Dallas-Fort Worth metroplex, and the highest transported loads were located downstream from those identified hotspots or where the most runoff was generated. Watershed managers can use pySELECT to develop best management practices on the specific areas and fecal sources that contribute fecal contamination into a waterbody.

8 February 2025 in Remote Sensing
Verified
Journal Article
Open access
PDF file
VSVaishali Swaminathan
Vaishali Swaminathan
ATAlex Thomasson
Alex Thomasson
NRNithya Rajan
Nithya Rajan
RHRobert G. Hardin
Robert G. Hardin
Early detection of nitrogen deficiency in cotton requires timely identification of stress symptoms like leaf chlorosis (yellowing) and canopy stunting. Chlorosis initially appears in older, lower-canopy leaves, which are often not visible in conventional nadir-looking imaging. This study investigates oblique ground-based multispectral imaging to estimate plant height and capture spectral details from the upper (UC) and lower (LC) cotton canopy layers. Images were collected from four camera pitch and height configurations: set 1 (30°, 2 m), set 2 (55°, 2 m), set 3 (68°, 3 m), and set 4 (70°, 1.5 m). A pre-trained monocular depth estimation model (MiDaS) was used to estimate plant height from aligned RGB images and an empirically derived tangential model corrected for perspective distortion. Further, the lower and upper vertical halves of the plants were categorized as LC and UC, with vegetation indices (CIgreen, CIrededge) calculated for each. The aligned images in set 1 had the best sharpness and quality. The plant height estimates from set 1 had the highest correlation (r = 0.64) and lowest root mean squared error (RMSE = 0.13 m). As the images became more oblique, alignment and monocular depth/height accuracy decreased. Also, the effects of perspective and object-scale ambiguity in monocular depth estimation were prominent in the high oblique and relatively low altitude images. The spectral vegetation indices (VIs) were affected by band misalignment and shadows. VIs from the different canopy layers demonstrated moderate correlation with leaf nitrogen concentration, and sets 2 and 3 specifically showed high and low differences in VIs from the UC and LC layers for the no and high-nitrogen treatments, respectively. However, improvements in the multispectral alignment process, extensive data collection, and ground-truthing are needed to conclude whether the LC spectra are useful for early nitrogen stress detection in field cotton.

28 February 2024 in arXiv
Verified
Preprint
Open access
PDF file
VSVaishali Swaminathan
Vaishali Swaminathan
JTJ. Alex Thomasson
J. Alex Thomasson
RHRobert G. Hardin
Robert G. Hardin
NRNithya Rajan
Nithya Rajan
Radiometric accuracy of data is crucial in quantitative precision agriculture, to produce reliable and repeatable data for modeling and decision making. The effect of exposure time and gain settings on the radiometric accuracy of multispectral images was not explored enough. The goal of this study was to determine if having a fixed exposure (FE) time during image acquisition improved radiometric accuracy of images, compared to the default auto-exposure (AE) settings. This involved quantifying the errors from auto-exposure and determining ideal exposure values within which radiometric mean absolute percentage error (MAPE) were minimal (< 5%). The results showed that FE orthomosaic was closer to ground-truth (higher R2 and lower MAPE) than AE orthomosaic. An ideal exposure range was determined for capturing canopy and soil objects, without loss of information from under-exposure or saturation from over-exposure. A simulation of errors from AE showed that MAPE < 5% for the blue, green, red, and NIR bands and < 7% for the red edge band for exposure settings within the determined ideal ranges and increased exponentially beyond the ideal exposure upper limit. Further, prediction of total plant nitrogen uptake (g/plant) using vegetation indices (VIs) from two different growing seasons were closer to the ground truth (mostly, R2 > 0.40, and MAPE = 12 to 14%, p < 0.05) when FE was used, compared to the prediction from AE images (mostly, R2 < 0.13, MAPE = 15 to 18%, p >= 0.05).