Due to its faster implementation and potential cost savings for estimating the bearing capacity of PHC pipe piles, the High Strain Dynamic Test (HSDT) offers an alternative approach to Static Load Test (SLT). The report presents a bearing capacity study via those methods with a sliding micrometer. And a Pile Driving Analyzer (PDA) imported from the United States is employed, to determine the design parameters of pile foundation engineering and provide the error sources of bearing capacity. Sliding micrometers with cone-shaped rings are embedded in the inner side of the pile piles every 1 m for measuring the strain. The law of stress and strain at various depths during loading is presented in this paper. As a new concept, the “inflection point” is proposed by the relationship between shaft resistance and relative displacement of pile-soil. By comparing the SLT and HSDT, the relationship between toe resistance and settlement of pile is demonstrated. This paper analyses the reliability and precision, and explore the error source so as to provide theoretical evidence for trail-pile testing in future. And the error of bearing capacity between SLT and HSDT with CAPWAP studies shows that the HSDT could provide adequate results for assessing the bearing capacity of PHC pipe piles.
Bentonite materials are extensively used in cutoff walls at landfill sites. This study calculates the stress and permeability characteristics of bentonite materials using the piezocone penetration test (CPTU) and ABAQUS simulations. The lateral effective stress of bentonite materials is evaluated using arching models, lateral squeezing models, and a modified lateral squeezing model. Pore pressure dissipation types are categorized into standard and non-standard, with the coefficient of consolidation obtained using the half dissipation time of excess pore pressure (t50) method. In the standard dissipation type, the excess pore pressure gradually dissipates over time after the cone stops penetrating. In contrast, the non-standard dissipation type is characterized by an initial increase in pore pressure until it reaches a maximum value, followed by a decrease to hydrostatic pressure. Additionally, the pore pressure dissipation process in bentonite cutoff walls is recorded and analyzed over various time intervals. Finally, the relationship between hydraulic conductivity and t50 at landfill sites is established based on standard and non-standard dissipation types using CPTU and ABAQUS methods. The t50 method is used for the standard dissipation type, while a modified t50m method is used for the non-standard dissipation type from CPTU and a t50m method is used in the non-standard dissipation type from CPTU. The t50m is the modified value derived from t50. Cutoff walls made from bentonite materials offer the advantage of enhancing the isolation effects and meeting the design requirement of permeability (1.0 × 10−7 cm/s).