Coffee husk, a major lignocellulosic waste derived from the coffee industry, was first ground into flour of fine particles of approximately 90 µm and then torrefied at 250 °C to make it more thermally stable and compatible with biopolymers. The resultant torrefied coffee husk flour (TCHF) was thereafter melt-compounded with polylactide (PLA) in contents from 20 to 50 wt% and the extruded green composite pellets were shaped by injection molding into pieces and characterized. Although the incorporation of TCHF reduced the ductility and toughness of PLA, filler contents of 20 wt% successfully yielded pieces with balanced mechanical properties in both tensile and flexural conditions and improved hardness. Contents of up to 30 wt% of TCHF also induced a nucleating effect that favored the formation of crystals of PLA, whereas the thermal degradation of the biopolyester was delayed by more than 7 °C. Furthermore, the PLA/TCHF pieces showed higher thermomechanical resistance and their softening point increased up to nearly 60 °C. Therefore, highly sustainable pieces were developed through the valorization of large amounts of coffee waste subjected to torrefaction. In the Circular Bioeconomy framework, these novel green composites can be used in the design of compostable rigid packaging and food contact disposables.
Combustion is the most commonly used technology to produce energy from biomass; nevertheless, there are still thermal efficiency problems in current biomass combustion furnaces and a lack of knowledge about the properties of residual biomasses that could be used as fuels. Aiming to contribute to knowledge of the potential of residual biomass for energy generation, this work reports on the implementation of a 2D computational model to study the combustion performance of several solid biomass fuels, and its application in the analysis of Lippia origanoides bagasse combustion. The model uses an Eulerian–Lagrangian approach; in the continuous phase, governing equations are solved, and in the dispersed phase, particles are tracked and the mass, momentum, species and energy transfer between the phases are calculated. The model was validated against experimental data from a combustor fueled by three biomasses: wood pellets, olive stone and almond shell. The results show deviations of less than 13%, with few exceptions, which indicates a good degree of agreement with experimental measurements compared with those reported by other studies on the subject. Furthermore, it was found that the stems of Lippia origanoides bagasse show similar performance to that of other biomass used as solid fuel, while the leaves present lower performance.
Biomass is the primary non-fossil energy source, especially in regions such as Central and South America, and holds immense potential for non-fossil energy. Utilizing waste biomass, mainly through gasification for syngas production, offers environmental advantages over direct combustion for electricity and heating. The sacha inchi seed shell (SIS), currently discarded, presents an untapped biomass resource. Hence, the significance of this work lies in assessing the gasification potential of SIS for decentralized power generation, targeting rural off-grid areas. Detailed modeling of mass, energy, and exergy flows was used to establish a self-sustaining 35 kW sacha inchi processing plant using Aspen Plus software. The best operational condition was identified at an equivalence ratio of 0.25, achieving 100 % carbon conversion efficiency and 73.5 % cold gas efficiency with a lower heating value of 6.126 MJ/kg. Exergetic analysis highlights heat exchangers and the power generator as the least efficient components (0.214 % to 27.85 %), contrasting with superior efficiencies in the gasifier, compressor, and cyclone (82.85 %, 85.5 %, and 96.13 %, respectively). Exergoeconomic assessment reveals an energy cost of 10.25 USD/GJ, notably lower than Colombian energy costs for equivalent power needs.
17 March 2026 in Journal of the Brazilian Society of Mechanical Sciences and Engineering