The current work deals with the fabrication of novel MoO3 nanostructured films with Ce and Cu co-doping through the spray pyrolysis route on a glass substrate maintained at 460 °C for the first time. The phase of developed films was approved by an X-ray diffraction study, and the crystallite size was determined between 82 and 92 nm. The optical transmission of the developed films was noticed to be reduced with doping and found between 45 and 90% for all films, and the absorption edge shifted to a higher wavelength with doping. The optical energy gap of the fabricated films was found to be reduced from 3.85 to 3.28 eV with doping. The developed films were used to degrade the harmful Eosin-Y dye under UV light. The system with 2% Ce and 1% Cu-doped MoO3 turned out to be the most effective catalyst for photodegradation of the dye in a period of 3H and almost degrade it. Hence, the MoO3 films prepared with 2% Ce and 1% Cu will be highly applicable as photocatalysts for the removal of hazardous dye from wastewater.
1 October 2014 in Materials Science in Semiconductor Processing
Cu2ZnSnS4 (CZTS) thin film was deposited on glass substrate by spray pyrolysis technique using a methanolic solution. This film was annealed under nitrogen atmosphere for an hour at different annealing temperatures. The effect of the annealing temperature on composition, structure, morphology, electrical, and optical properties of CZTS films was investigated. Energy dispersive x-ray analysis showed that after the annealing process, the atomic ratio values tend to their stoichiometric values. Moreover, the X-ray diffraction (XRD) and Raman spectroscopy revealed a kesterite structure with (112) preferential orientation for both as-deposited and annealed CZTS films. Moreover, they exhibited an improvement in crystallinity after annealing which was confirmed by SEM analysis. The conductivity of the heated CZTS films showed also an important increase in crystallinity. The absorption edge shifted toward lower wavelengths leading to an increase in band gap energy for the annealed CZTS films.
This study communicates the structural, electronic, optical, and thermoelectric properties of a perovskite TlXF3 (X: Zn, Sr) crystal structure using first-principles calculations. Both compounds were found structurally as well as thermodynamically stable in cubic phase. To check the kinetic stability, the phonon frequancy band structure is calculated which indicates that there is no negative frequency in the phonon spectrum, which confirms the dynamic stability of TlXF3. The bandgaps of both compounds belong to insulating region. The TlSrF3 exhibits direct bandgap of 4.37 eV at X symmetry point while TlZnF3 possess indirect bandgap of 3.95 eV (M-X). Using HSE functional, the calculated electronic bandgaps of TlSrF3 and TlZnF3 are 5.74 eV(X-X) and 5.36 eV (M-X), respectively. The analysis of electronic states in band structure shows that for TlSrF3, the top of valence band is composed of the F-p states whereas the states in lower potion of conduction band are impacted by the significant contribution of Tl-p orbital states. In case of TlZnF3, the states near the valence band maxima and conduction band minima are coming mainly form Tl atom. The effect of spin–orbit coupling (SOC) on the electronic band structure is also considered. The SOC in the valance band is negligible, while in the conduction band it shows a dominant effect at Γ-point in both TlSrF3 and TlZnF3 compounds. The dependence of thermoelectric properties such as electrical conductivity σ, Seebeck coefficient (S), Power factor (PF), electronic thermal conductivity (κ) and figure-of-merit (ZT) as a function of carrier concentration and temperature are investigated. The optical properties were also studied to understand the response of TlXF3 to incident photons of energies upto 14 eV. We conclude that the TlXF3 are promising candidates for electronic, thermoelectric and optoelectronic devices.
Mixed metallic oxides are getting increasing attention as novel electrode materials for energy conversion devices. However, low mixed ionic-electronic conductivity and high operating temperature hamper the practical applications of these devices. This study reports an effective strategy to improve the conductivity and performance of the fuel cell at low temperature by partially incorporating graphene in the Li0.1Cu0.2Zn0.7-oxide (LCZ) composite. The proposed cathode material is synthesized via the cost effective conventional solid-state route. Graphene incorporated LCZ shows excellent performance, which is attributed to the favorable charge transport paths offering low area-specific resistance. An X-ray diffractometer (XRD) and scanning electron microscope (SEM) are employed for microstructural and surface morphological analyses, respectively. Electrical conductivities of all the materials are determined by the DC four probe method, and interestingly, LCZ-1.5% graphene exhibits an excellent conductivity of 3.5 S/cm in air atmosphere at a temperature of 450 °C with a minimum value of 0.057 Ωcm2 area-specific resistance (ASR) that demonstrates significantly good performance. Moreover, the three-layer fuel cell device is fabricated using sodium carbonated Sm0.2Ce0.8O (NSDC) as an electrolyte, which can operate at low temperatures exhibiting open circuit voltage 0.95 V and shows a peak power density, i.e., 267.5 mW/cm2 with hydrogen as the fuel.