The use of metallurgical slags in cement production depends on the phases present in such slags, which are affected by changes in slag composition as well as the cooling rates adopted during solidification. In this work, slags with distinct chemical compositions were melted and subjected to different cooling conditions. Slag samples were characterized by X-ray diffraction to identify and quantify mineralogical phases and by X-ray fluorescence to determine chemical composition. The microstructure of the samples was characterized by scanning electron microscopy coupled to energy dispersive spectroscopy for phase identification. The solidification of the slags was simulated using FactSage™ for solidification path evaluation, enabling a comparison of the phases determined by thermodynamic equilibrium with those analysed in slag samples. Slags with low basicity (CaO/SiO2 <1.25) and Al2O3 content of 11 wt% exhibited a high glassy phase content depending on the cooling conditions. The phases formed in slags with higher basicity (1.4 and 3.8) were less affected by cooling rate and were different silicates, such as larnite, merwinite, monticellite, akermanite, gehlenite and melilite, whereas slags with basicity ≥1.37 exhibited RO phase (solid solution of FeO, MgO, CaO and MnO).
The anode effect can occur during neodymium and didymium oxide electrowinning, causing a surge in the electrochemical cell voltage, interrupting the process, and increasing the greenhouse gas emissions. In this work, we develop a mathematical model, based on the mass balance of gas bubbles evolving from the anode, to understand the influence of some process parameters on the anode effect. The anode effect occurs due to bubble coverage and limitations on the mass transfer of the oxide species. Variables such as current density, oxide content, viscosity, and electrolyte composition play an important role in the anodic process. Finally, we propose a mechanism for the occurrence of the anode effect during Nd or Di (Nd–Pr) oxide electrolytic reduction based on models used in aluminum electrolysis.