The region of Upper Silesia, located in southern Poland, is characterised by very high emissions of carbon dioxide into the air—the annual emission exceeds 33 Mt CO2 and the emission ‘per capita’ is 7.2 t/y in comparison to the EU average emission per capita 6.4 t/y and 8.4 t/y for Poland in 2019. Although in the region there are over 100 carbon dioxide emitters covered by the EU ETS, over 90% of emissions come from approximately 15 large hard coal power plants and from the coke and metallurgical complex. The CCUS scenario for Upper Silesia, which encompasses emitters, capture plants, transport routes, as well as utilisation and storage sites until 2050, was developed. The baseline scenario assumes capture of carbon dioxide in seven installations, use in two methanol plants and transport and injection into two deep saline aquifers (DSA). The share of captured CO2 from flue gas was assumed at the level of 0.25–0.9, depending mainly on the limited capacity of storage. To recognise the views of society on development of the CCUS technologies in Upper Silesia, thirteen interviews with different types of stakeholders (industry, research and education, policy makers) were conducted. The respondents evaluated CCU much better than CCS. The techno-economic assessment of CCUS carried out on a scenario basis showed that the economic outcome of the scenario with CCUS is EUR 3807.19 million more favourable compared to the scenario without CO2 capture and storage.
9 May 2012 in International Journal of Energy Research
This article presents the results of an eco-efficiency assessment of the application of large-scale rechargeable battery technology in electricity generation from coal. The eco-efficiency of electricity production in a 350 MW coal-fired power plant was calculated. Two production variants were compared: with the use of a lithium-ion battery of a 400 MWh capacity to optimize the operation of power blocks and without using the battery. Hard coal is one of the main fossil fuels used to generate electricity in Poland. Despite the growing share of electricity from renewable sources, this situation will persist for many more years. The main reasons for this are the high costs and long-lasting process of moving away from fossil fuels in the energy sector. Therefore, any technical solutions that can temporarily reduce the negative impact of coal-based power engineering on the environment should be considered. At the same time, the economic aspects of such solutions must be taken into account. That is why the eco-efficiency assessment method was chosen, which integrates economic and environmental aspects. The obtained results of the analyses indicate the occurrence of environmental and economic benefits resulting from the use of the battery in coal-fired power plants. It has been found that battery-based technology is more eco-efficient than technology without such a battery. A sensitivity analysis was carried out, which allowed the impact of individual computational variables on the eco-efficiency assessment result to be assessed. The results indicate that fuel prices (coal and heavy fuel oil—mazout) and CO2 emission allowances have the greatest impact on the eco-efficiency of the analyzed technology. It was also found that the factors related to the battery, such as its efficiency, life span, decrease of the capacity after 10 years of operation, and construction cost, have a much smaller impact on the results.
The article highlights sorptive properties of poultry litter. Preliminary studies on sorption of Cd2+, Cu2+, Ni2+, Pb2+, Zn2+ ions at the concentration range of 1–1000 mg L-1 were carried out. Langmuir and Freundlich models were used to determine the potential capacities of the poultry litter. Sorption parameter outcome from isotherms exhibited the following order: Pb > Cd > Cu > Zn > Ni. During the batch adsorption experiment, a decrease of the absorbance of solutions in the UV-Vis range was observed, proportional to the increase in the concentration of metals in the solutions. This phenomenon was associated with the precipitation of complexes of fulvic/humic-like compounds and uric acid with metals. The decrease in dissolved organic carbon (DOC) concentration confirmed previous assumptions. The FT-IR spectroscopy showed significant role of uric acid in Cd2+, Pb2+, Zn2+ sorption. FT-IR measurements allowed determining the type of active sites involved in sorption, especially carboxylic groups. The findings should be helpful in soil reclamation practices with poultry litter.