The Inconel 718 superalloy, a precipitation-hardenable material, is of particular interest for applications involving components operating under extreme conditions due to its excellent mechanical properties, high corrosion resistance at temperatures up to 700 °C, and good workability. At high temperatures, thermal transfer processes are crucial for temperature distribution across the component’s section, structural transformations, and variations in the alloy’s properties. The history of accidental overheating events is critical for the microstructure and properties of the alloy. Studies on thermal transfer in the Inconel 718 alloy available in the literature typically focus on the alloy in its as-delivered state. The experimental research presented in this paper examines the influence of repeated overheating history on the thermal diffusivity of the alloy.
The Inconel 718 alloy is a nickel-based superalloy that can be strengthened through precipitation hardening. Due to its exceptional mechanical properties, high corrosion resistance, and good workability, it is particularly suitable for applications where components operate in corrosive environments at temperatures up to 600 °C. Under these conditions, overheating frequently occurs, leading to structural transformations and changes in mechanical properties. This experimental study examined the effect of repeated overheating on the alloy’s structure, the formation of oxide layers, and hardness. The cyclic overheating process was simulated using thermal shocks induced by solar energy, with temperatures exceeding the recommended range, between 700 and 1000 °C. Morphological characterization, elemental chemical analysis, qualitative phase analysis, and microhardness measurements highlighted the transformations induced by cyclic thermal stress at high temperatures.
The precipitation-hardenable nickel-based superalloy Rene 41 exhibits remarkable mechanical characteristics and high corrosion resistance at high temperatures, properties that allow it to be used in high-end applications. This research paper presents findings on the influence of thermal shocks on its microstructure, hardness, and thermal diffusivity at temperatures between 700 and 1000 °C. Solar energy was used for cyclic thermal shock tests. The samples were characterized using microhardness measurements, optical microscopic analysis, scanning electron microscopy coupled with EDS elemental chemical analysis, X-ray diffraction, and flash thermal diffusivity measurements. Structural transformations and the variation of properties were observed with an increase in the number of shocks applied at the same temperature and with temperature variation for the same number of thermal shocks.