8 January 2019 in IEEE Transactions on Antennas and Propagation
A wideband, low-profile, tightly coupled antenna array with a simple feed network is presented. The dipole and feed network in each unit cell are printed on both sides of a single RT/DuroidTM 6010 substrate with a relative dielectric constant of 10.2. The feed network, composed of meandered impedance transformer and balun sections, is designed based on Klopfenstein tapered microstrip lines. The wide angle impedance matching is empowered by a novel wideband metasurface superstrate. For the optimum design, scanning to 70° along the E-plane is obtained together with a very high array figure of merit, PA = 2.84. The H-plane scan extends to 55°. The broadside impedance bandwidth is 5.5:1 (0.80 – 4.38) GHz with an active VSWR value ≤ 2. The overall height of the array above the ground plane is 0.088 λL, where λL is the wavelength at the lowest frequency of operation. A prototype was fabricated and tested to confirm the design concepts.
11 May 2018 in IEEE Transactions on Antennas and Propagation
For many leaky-wave antennas (LWAs), it is challenging to realise beam scanning through the broadside. A problem is the presence of an open stopband (OSB), which restricts radiation in the broadside direction. In this paper, a novel substrate integrated waveguide (SIW)-based LWA is described to overcome the OSB problem and provide beam scanning continuously from the backward to the forward direction from a conventional periodic LWA. It is demonstrated that the n = -1 spatial harmonic can be excited efficiently from a SIW LWA and enables broadside radiation. However, it was found in our initial design that when the beam scans through the broadside the cross-polarization level increases significantly compared to the beam close to the backfire direction. A technique is developed to reduce the cross-polarization level. As a result a new antenna configuration is created. The antenna design has been realized and measured to validate the concept. The measured beam scanning range of the prototype is from -74° to + 45° (119° of beam scanning) when the frequency sweeps from 7.625 to 11 GHz, and the measured cross-polarization level is 20.8 dB low at the main beam direction for the broadside beam.
16 October 2019 in IEEE Transactions on Antennas and Propagation
A composite right/left-handed (CRLH) leaky-wave antenna (LWA) can effectively scan the radiation beam from backward to forward direction. However, in most cases a large range of frequency sweep is required to achieve a wide-angle beam scan, which could limit their applications. An in-depth study is conducted on an equivalent circuit model for a CRLH LWA unit cell to find the controlling parameters on the frequency sweeping range. A systematic design guideline is given for a CRLH LWA for a wide-angle beam scan in a flexibly chosen frequency range. It is shown that beam scanning by sweeping frequency in a target range can be achieved by systematically designing the unit cell parameters. To verify our approach a novel CRLH unit cell is developed and used to design an LWA for a wide-angle beam scan in a narrow frequency range. Finally, the concept is validated through realization of the antenna and its measurement. The measured results show that the antenna prototype can scan its beam from –56° to +51° when frequency sweeps from 5.1 to 6.11 GHz (i.e., 18.02% of fractional bandwidth).
18 November 2019 in IEEE Antennas and Wireless Propagation Letters
A leaky-wave antenna (LWA) on a substrate integrated waveguide (SIW) with continuous beam scanning capabilities and improved gain is presented. A 1-D longitudinal slot array SIW antenna is used as the main radiating element. It was found that due to the capacitive effect of the slot, an open-stopband (OSB) restrains broadside radiation. Although a reduction of the bandgap can be achieved when the slots are closer to the center, the radiation performance of the LWA degrades around the broadside as the beam scans from backward to forward. Initially, the capacitive effect was mitigated, and hence the OSB was suppressed by introducing a group of three shorting vias at the opposite side of each longitudinal slot. However, the gain of the antenna drops significantly around its upper scan angles in the forward directions. To improve the radiation performance further, the centre via of each of the via group is replaced by a transverse slot. The new unit cell is then used to design a modified 1-D slot array LWA, and the antenna is analyzed, prototyped and measured to verify the concept.
27 December 2018 in IEEE Antennas and Wireless Propagation Letters
1 July 1994 in IEEE Transactions on Antennas and Propagation
Two formulations are presented for the mutual admittance of rotated rectangular apertures in a ground plane. One extends an earlier solution, and the other is a third-order asymptotic formula that is shown to be accurate when the apertures satisfy the Rayleigh distance criterion. These formulations are combined with a conventional mode-matching approach to study coupling between rotated horns. Results are presented for both coupling formulations, and these demonstrate excellent agreement with experiment for coplanar pyramidal and sectoral horns.