1 October 2015 in Journal of the Korean Physical Society
10 December 2021 in Physical Review Accelerators and Beams
An active plasma lens (APL) focuses the beam in both the horizontal and vertical planes simultaneously using a magnetic field generated by a discharge current through the plasma. A beam size of can be achieved within a short distance using a focusing gradient on the order of . The APL is therefore an attractive element for plasma wakefield acceleration, because an ultrasmall size of the witness electron beam is required for injection into the plasma wakefield to minimize emittance growth and to enhance the capturing efficiency. When the drive beam and witness electron beam copropagate through the APL, interactions between the drive and witness beams, and the plasma must be considered. In this paper, through particle-in-cell simulations, we discuss the possibility of using an APL for the final focusing of the electron beam for the AWAKE RUN 2 experiments. It is confirmed that the amplitude of the plasma wakefield excited by proton bunches remains the same even after propagation through the APL. The emittance of the witness electron beam increases rapidly in the plasma density ramp regions of the lens. Nevertheless, when the witness electron beam has a charge of 100 pC, emittance of 10 mm mrad, and bunch length of , its emittance growth is not significant along the active plasma lens. For small emittance, such as 2 mm mrad, the emittance growth is found to be strongly dependent on the rms beam size, plasma density, and multiple Coulomb scattering.
21 December 2023 in IEEE Transactions on Applied Superconductivity
This work presents a modified lumped-circuit model for a saddle-shaped no-insulation (NI) high temperature superconductor (HTS) coil in overcurrent, which is defined by the situation that azimuthal current is close to or greater than the critical current. We suggested the variation of the coil's circuit parameters, such as inductance, ‘index’ resistance, and characteristic resistance. We modified the base assumptions of the conventional lumped-circuit model and experimented to validate the suggested model. An 82-turn saddle-shaped NI coil was fabricated, and terminal voltage and magnetic field were measured during the overcurrent test in a 77 K liquid nitrogen bath. Compared to the conventional model, our modified lumped-circuit model reduced the error between measurement and simulation from 44.2% to 2.9%. We inversely calculated the variation of circuit parameters and magnet constant, which cannot be the constant value, and the results are presented.
28 March 2023 in IEEE Transactions on Applied Superconductivity
One of the possible obstacles for future high temperature superconductor (HTS) undulator is undesirable field distribution changes due to screening current induced field (SCF). In this study, we investigated the effects of SCF of short period planar undulator magnet using a numerical simulation, specifically H-formulation with nonlinear BH curve of iron core considered. First, we used a periodic screening current analysis model to investigate $n$ -value and spool-by-spool critical current dependent hysteresis behavior of undulator field change due to SCF. The results with selected $n$ -value and spool-by-spool critical current values may be used to estimate the possible variations of undulator field due to SCF. After that, the temporal behavior of undulator field with and without the current sweep reversal method is also investigated.
19 August 2021 in IEEE Transactions on Instrumentation and Measurement
A pepper-pot diagnostic device was developed to accurately and robustly retrieve particle distribution in horizontal and vertical phase spaces by single-shot emittance measurements. Two masks that differ in both composition and manufacturing method were fabricated: one made of phosphor bronze by an optical lithography process and another made of stainless steel (SUS) by laser cutting. Scanning electron microscope (SEM) measurements of the two masks revealed that the former is superior in terms of regularity and shape of the mask holes and is therefore more suitable to use. A new image-processing algorithm, namely, cluster noise removal method, was developed which improves the resolution of the phase-space distribution measurements over traditional methods. The device was tested in experiments with low-energy argon beams generated by an electron-cyclotron resonance (ECR) ion source at Korea Institute of Fusion Energy (KFE), Daejeon, South Korea. The results show that the diagnostics can robustly and reliably retrieve the four-dimensional (4-D) phase-space distribution of ion beams with a single-shot measurement.
21 December 2023 in IEEE Transactions on Applied Superconductivity
This work presents a distributed-circuit model for analyzing experimental results of fast-ramping behaviors of a saddle-shaped REBCO dipole magnet wound with a bundled conductor. Terminal voltage and center magnetic field were measured during the test performed at 77 K temperature. Our distributed-circuit model accurately reproduced the observed electromagnetic behaviors, demonstrating its validity for the fast-ramping operation of an HTS magnet. We also analyzed the current discrepancy between bundled conductors and Joule dissipation due to the various ranges of contact resistivity.