24 October 2018 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
Nowadays, the development of electric vehicle equipped with a two-speed automatic transmission has become a hotspot. As well known, the automatic transmission operates with power loss including gear meshing loss, bearing loss, and oil churning loss. This paper focuses on the bulk temperature prediction of a two-speed automatic transmission using thermal network method. An integrated model, including an efficiency model and a heat balance model, is proposed, which makes it possible to predict power loss, bulk temperature, and temperature distributions under different conditions. In the efficiency model, each part of power losses from gear meshes is studied to calculate the summation of mechanical power losses in the transmission, including losses of gear meshing, bearing and oil churning. In the heat balance model, the entire gearbox is divided into elements with a uniform temperature connected by thermal resistances which account for conduction, convection, and radiation, based upon the first law of thermodynamics for transient conditions. The effectiveness of bulk temperature prediction using thermal network method is validated by the comparison between simulation results and the experimental data. Consequently, this study on heat transfer characteristics, thermal characteristics, and bulk temperature prediction of the two-speed automatic transmission has significant academic and application values.
5 April 2019 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
Tooth modification is critical when designing high-performance gear transmission systems. However, it is difficult to accurately calculate the system deformation and tooth modification amount using the traditional empirical formula. Although the finite element method provides accurate results, it is time consuming and its direct application to tooth modification for multistage geared systems is difficult. This study proposes a novel methodology to define tooth modification in both width and profile directions, which can be used for multistage spur gears. First, a housing-transmission coupled dynamic model is built, and the actual meshing state of each gear pair is obtained from dynamic simulation. Lead and profile modification are then conducted sequentially using the actual meshing state as an input. As the optimal tooth modification parameter is determined by the system dynamic response, and the tooth modification in turn influences the system dynamic response, the “dynamic simulation” and “tooth modification” are repeated iteratively until the modification parameter converges. Taking the drum driving system of a shearer as an example, the optimal tooth modification parameter is obtained after three iterations, and the dynamic factor and maximum tooth contact stress clearly decreased after applying the optimal tooth modification.
1 June 2018 in AEU - International Journal of Electronics and Communications